Panasonic EWBU30 Operations Instructions download pdf (Page 8)

GB9

English

GB10

English

Taking a Reading

1. Press the Off/On Start button.

After the entire display has been lit, the cuff will be pressurized

and measurement will be taken automatically.

The pressure value, mark, and the time will be displayed.

•

The heart mark will flash when pulse is detected during

depressurization.

•

2. After the measurement is completed, the unit will beep, and

the blood pressure value and pulse rate will be displayed.

The cuff is depressurized automatically.

If the measured value is in the high blood pressure region, the

values will flash for approximately 5 seconds.

The mark or mark will display after flashing for

5 seconds when movement of the body or irregular pulses were

detected during the measurement. (See pages GB13 and GB14.)

The mark will flash.

The mark is displayed at the pulse rate display area when the

pulse rate could not be measured.

•

3. To store the measured values, proceed to page GB11.

To complete the measurement, press the Off/On Start button.

* If you forget to switch off the unit it will do so automatically after

approx. 2 minutes.

Date and time is displayed when the display of date and time is

set to ON.

See page GB6 to turn off the display.

•

Taking a measurement with manual pressurization

Take a measurement with manual pressurization if appropriate pressurization is not

possible after repeated pressurization.

Value 30–40 mmHg higher than

expected systolic blood pressure

1. With the unit turned off, press the Off/On Start

button and hold it to pressurize the cuff to 30–40

mmHg higher value than the expected systolic blood

pressure.

The pressurization value on the display will increase

from 0 mmHg while holding down the Off/On Start

button.

It can be pressurized up to 280 mmHg.

CAUTION:

It may cause temporarily internal bleeding when

pressurized more than necessary.

•

2. Release the Off/On Start button.

When an Error Occurs During Measurement

A will appear on the display to indicate that measurement was

unsuccessful and should be performed again.

Before performing another measurement, always press the Off/On Start button to turn off

the unit and make sure to allow a rest period of 4 to 5 minutes before starting again.

Advice:

In general, blood pressure measurements are lower for the second measurement

because you are less nervous and are more tranquil.

For people who easily get tense, measuring twice each time is very effective.

It is recommended to store all values when performing two measurements or more.

When taking two measurements, always stay quiet for 4 to 5 minutes after the first

measurement before taking the second measurement.

9-10 2009/07/09 8:18:11

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Panasonic EWBU30 Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Blood pressure units Panasonic EWBU30