Panasonic HCX1E Operations Instructions Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
24
DVQX1102
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1 Open the SD card slot cover and
insert (remove) the SD card into
(from) the card slot B.
One SD card can be inserted into each of the
card slot 1 and the card slot 2.
Face the terminal side C in the direction
shown in the illustration and press it straight
in as far as it will go.
Press the center of the SD card and then pull
it straight out.
2 Securely close the SD card slot
cover.
Do not touch the terminals on the back of the
SD card.
Do not apply strong shocks, bend, or drop the
SD card.
Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB Cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or this
unit.
Do not expose the terminals of the SD card to
water, dirt or dust.
Do not place SD cards in the following areas:
j In direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant
difference in temperature (condensation
can occur.)
j Where static electricity or electromagnetic
waves occur
To protect SD cards, return them to their
cases when you are not using them.
About disposing of or giving away the SD
card. (l 6)
When using an SD card for the first time, it is necessary to format the SD card. (l 29) When the
SD card is formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be
restored.
Access lamp A
When this unit is accessing the SD card,
the access lamp lights up.
HC-X1_EGC_Simple.book 24 ページ 2016年11月1日 火曜日 午前10時21分
24
DVQX1102
Umetanje/vađenje SD-kartice
Kada prvi put upotrebljavate SD-karticu, potrebno ju je formatirati. ( 29) Kada se SD-kartica
formatira, svi se snimljeni podaci brišu. Nakon što se podaci izbrišu, više ih nije moguće vratiti.
Oprez:
provjerite je li se lampica pristupa isključila.
Nemojte dirati kontakte na stražnjoj strani
SD-kartice.
SD-karticu nemojte izlagati snažnim
vibracijama, savijati je ili bacati.
Električne smetnje, statički elektricitet ili kvar
ovog uređaja ili SD-kartice mogu oštetiti ili
izbrisati podatke spremljene na SD-kartici.
Kada lampica pristupa kartici svijetli,
nemojte:
vaditi SD-karticu
isključivati uređaj
umetati i odspajati USB-kabel
izlagati uređaj vibracijama ili udarcima
Izvršavanje gore navedenih radnji dok
lampica svijetli može rezultirati oštećenjem
podataka/SD-kartice ili uređaja.
Kontakti SD-kartice ne smiju biti izloženi
vodi, prljavštini ili prašini.
SD-kartice nemojte ostavljati na sljedećim
mjestima:
izravno izložene sunčevu svjetlu
na izrazito prašnjavim ili vlažnim mjestima
u blizini grijača
na mjestima izloženima značajnim
temperaturnim razlikama (može doći do
kondenzacije)
na mjestima gdje je uređaj
izložen statičkom elektricitetu ili
elektromagnetskim valovima
Da biste zaštitili SD-kartice, vratite ih
u njihove zaštitne kutijice kada ih ne
upotrebljavate.
Odlaganje ili ustupanje SD-kartice. ( 6)
Lampica pristupa A
Kada uređaj pristupa SD-kartici, lampica
pristupa svijetli.
1 Otvorite poklopac utora za SD-
karticu i umetnite SD-karticu u utor
za karticu B ili je izvadite iz njega.
Po jedna SD-kartica može se umetnuti u
utor za karticu 1 i utor za karticu 2.
Stranu s priključkom C okrenite u smjeru
prikazanom na slici i ravno gurnite do kraja.
Pritisnite sredinu SD-kartice i ravno je izvadite.
2 Čvrsto zatvorite poklopac utora
za SD-karticu.
Page view 23
1 ... 23 24 25 ... 52

Comments to this Manuals

No comments