Panasonic EY6450GQKW User Manual download pdf (Page 4)

-

4

-

Read “the Safety Instructions” booklet

and the following before using.

. ADDITIONAL

SAFETY RULES

1) Use auxiliary handle (support han-

dle) supplied with the tool. Loss of

control can cause personal injury.

2) Be aware that this tool is always in

an operating condition, since it does

not have to be plugged into an elec-

trical outlet.

3) When drilling or driving into walls,

floors, etc., “live” electrical wires may

be encountered. DO NOT TOUCH

THE CHUCK OR ANY FRONT

METAL PARTS OF THE TOOL!

Hold the tool only by the plastic han-

dle to prevent electric shock in case

you drill or drive into a “live” wire.

4) If the bit becomes jammed, im-

mediately turn the main switch off

to prevent an overload, which can

damage the battery pack or motor.

Use reverse motion to loosen

jammed bits.

5)

Do NOT operate the Forward/Reverse

lever when the main switch is on.

The battery will discharge rapidly

and damage to the unit may occur.

6) During charging, the charger may

become slightly warm. This is nor-

mal. Do NOT charge the battery for

a long period.

7) Use only a dry, soft cloth to wipe

the unit. Do NOT use a damp cloth,

thinner, benzine, or other volatile

solvents for cleaning.

8) When storing or carrying the tool,

set the Forward/Reverse lever to

the center position (switch lock).

9) Do not strain the tool by holding the

speed control trigger halfway (speed

control mode) so that the motor stops.

10) Do not operate the speed selector

switch (LOW-HIGH) while pulling on

the speed control trigger. This can

cause the rechargeable battery to

wear quickly or damage the internal

mechanism of the motor.

11) Young children should be supervised

to ensure that they do not play with

appliance.

12) Wear ear protectors when using the

tool for extended periods.

. ASSEMBLY

Attaching or removing bit

NOTE:

When attaching or removing a bit,

disconnect battery pack from tool

or place the switch in the center

position (switch lock).

This tool is equipped with a keyless

drill chuck.

1. Attachment

Insert the bit and turn the lock col-

lar clockwise (looking from the

front) to tighten firmly until it stops

clicking.

Lock collar

2. Removal

Turn the lock collar counterclockwise

(looking from the front), then remove

the bit.

3. Storage

Keep the bit in bit holder when not in

use.

Rem ove the bat tery pa ck to

expose the bit storage compart-

ment inside the handle housing.

Bits up to 50

mm (1-31/32

inch) long can

be stored here.

NOTE:

If excessive play occurs in the

chuck, secure the drill in place and

open the chuck jaws by turn-

ing the lock collar and tighten

the screw (left-handed screw) with

a screwdriver by turning it counter-

clockwise (viewed from the front).

1 2 3 4 5 6 7 8 9 ... 67 68

Comments to this Manuals

No comments