Panasonic SHALL1CEG User Manual download pdf (Page 18)

- 18 -

You can change this unit’s name on the network, and use specific IP

address, subnet mask, default gateway, primary DNS, etc.

Preparation

≥ Complete the network settings.

1 Check this unit’s IP address (l 26), and note it down.

2 Connect your device to the same network as this unit.

3 Start an Internet browser on your device and then type this

unit’s IP address into the address field to display the settings

page.

≥ It may take a few minutes until the settings page is displayed depending on

the environment. In that case, reload the browser.

≥ If the unit is connected with Wi-Fi, only a device name can be changed.

Close the settings page after changing the device name.

– To change the device name, select “Change”, and type a new device

name, and then select “Apply”.

4 Type a device name and then select “Next”.

≥ Refer to the step 5 of “Using an Internet browser” (l 14) for details on a

device name.

5 Select and input the details.

≥ If your network requires specific settings, select “DHCP” to disable DHCP.

– You can use specific IP address, subnet mask, default gateway, primary

DNS, etc.

6 Select “Connect” to apply the settings.

≥ When the connection is established, the network indicator (blue) lights up.

To make network-related settings

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

No comments

Panasonic SHALL1CEG User Manual Page 18