Panasonic NE-1757 User Manual download pdf (Page 16)

Installation Instructions for Stacking

Important

1. Disconnect the power cord from the wall receptacle

before attempting installation.

2. For stacking installation, you must use the

PANASONIC “Joint Plate” which is enclosed with

this unit.

3. Combination of the unit for stacking is limited within

only the following PANASONIC models.

NE-1257, NE-1757

4. The maximum stacking height is two units.

Preparation

Be sure the oven cavity is empty.

Installation

1. Stack the units and remove the screws from

individual unit as shown in Fig. 1.

2. Two projections on the joint plate must face away

from the oven.

3. Attach PANASONIC Joint Plate to top of the base

unit first by using the on the base 3 screws

previously removed. See Fig. 2.

4. Carefully place the top unit on the base so as to

align the five screw holes of the top unit with those

of the Joint Plate. Then attach and tighten five

screws. See Fig. 3.

Fig. 1.

Sanitary Counter Top Seal

When this microwave oven units are stacked on a

counter top, their base must be sealed in accordance

with N.S.F. Standards as per the following instructions.

1. Microwave oven should be located on a level

counter top surface. Complete the electrical,

connections.

2. Thoroughly clean the microwave oven bottom

perimeter and the counter top area around the

microwave oven perimeter.

3. Lay a generous bead of silicone seal around the

entire perimeter of the two microwave oven bottom.

4. Smooth the silicone seal into the crevice with finger

or tool to provide a cove seal.

Note: Remove the Air Filter from the front of the oven

before applying silicons.

DO NOT FORGET to re-install the Air Filter after

applying silicons.

- 16 -

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comments to this Manuals

No comments

Panasonic NE-1757 User Manual Page 16

Comments to this Manuals