Panasonic SC-HT730 User Manual download pdf (Page 6)

RQT7972

Simple setup

[HT933]

1 Attach the pipe to the base.

1 Thread the speaker cable through the base.

2 Insert the pipe.

Secure the pipe to the base.

Ensure the screws are

securely fastened by lightly

tightening the left and right

side screws alternately until

fully tightened. (The heads of

the screws protrude slightly

even if you have fully

tightened them.)

2 Attach the stand to the speakers.

≥

There is no difference between the right and left speakers and stands.

≥Using the polyfoam included with this unit may be convenient.

Ensure the stand is fastened on straight by lightly tightening the top

and bottom screws alternately until fully tightened.

∫ Front speaker height

(Assembled diagram)

3 Adjust the speaker height.

≥Check the screws you tightened in procedures 1 and 2 if the pipe

and speaker are loose.

e.g. Attaching the stand to the lower rear

STEP1

Front speaker assembly

2 Front speakers 2 Bases2 Pipes 4 Small screws4 Large screws

The supplied stands are specially designed for

attachment to Panasonic SB-PF920 front speakers.

Only use as indicated in this setup.

Lessen excess

speaker cable.

Thread the speaker

cable through here.

Cable

Groove

Holes for screws

Insert the pipe while gently

pulling on the speaker cable.

Rear side of base

Cable

Large

screws

Small screws

Front speaker

Polyfoam

Connection terminals

Mounting plate

You can also attach to the upper rear of the speaker.

The height of the speaker is indicated in the diagram on the

right when attaching the stand to the upper rear or lower rear of

the speaker.

For your reference

You can enjoy good acoustics by

adjusting the height of the speaker to

the height of the television so the

center positions of both are

approximately the same.

1,138 mm

(44

/16z)

Speaker

Base

968 mm

(38

/8z)

796 mm

(31

/32z)

625 mm

(24

/32z)

678 mm

(26

/16z)

Stopper

screw

Do not

remove.

You can adjust within this range.

Attach to lower

rear of speaker

Attach to upper

rear of speaker

Pipe

Stopper screw

Screw to stop mounting plate from

moving or sliding below this point.

1 Loosen the attached speaker mounting

plate screw until the attached speaker is

slightly loose and adjustable.

2 With one hand on the base and the other

holding the speaker adjust the height of

the speaker up and down.

≥After adjusting the height tighten the screw

on the mounting plate securely.

Be careful not to loosen the screw

too much or the speaker may detach

and fall.

Phillips-head screwdriver

Front speaker assembly

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Comments to this Manuals

No comments

Panasonic SC-HT730 User Manual Page 6

Comments to this Manuals

Related products and manuals for Home Theater Systems Panasonic SC-HT730