Panasonic UT-101 Owner's Manual download pdf (Page 5)

www.havis.com • 1-800-524-9900

10) If any of the Side Hold-down Lugs or Front/Rear Fences are covering ports,

loosen the Lug/Fence screw and gently slide the Lug/Fence along its slot

until port is uncovered. Retighten the screws to 22 in-lbs (0.25 Nm) ± 10%.

NOTE: It may not be possible to provide access to all ports on laptop. For your safety, it is

important that all Lugs and Fences be rertained for securing the laptop in place.

11) Make sure your laptop is secure on the Universal Laptop Mount prior

to installation in a vehicle.

Final Check List:

Laptop is in contact with the Front Fences

Side Hold-down Lugs are set to proper height and are in contact

with the deck of the laptop

Laptop is in contact with the Rear Fences

No vital ports or switches are covered by the Side Hold-down Lugs

or Front/Rear Fences where possible

5) If the Side Hold-down Lugs installed by the factory are too short, please

follow Steps 5a and 5b. Otherwise, proceed to Step 6.

5a) Locate the adjustment screw for each of the four Side Hold-down Lugs.

Remove the Lug by loosening the screw with the provided L-shaped Wrench.

5b) Take the four Tall Side Hold-down Lugs from the Packaging and install the

Vinyl Caps and Bumbers on each Lug. Re-install the Tall Side Hold-down

Lugs into the slots on the Universal Laptop Mount and tighten the screws.

Make sure the Lugs t over the side of the laptop before continuing.

8 5

Conguration (continued) Conguration (continued)

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Panasonic UT-101 Owner's Manual Page 5