Panasonic CF-W2 User Manual download pdf (Page 23)

Getting Started

Starting Up/Shutting Down

1 Open the display.

A Slide the latch (A) located at the front.

B Lift open the display.

z Do not open the display wider than necessary (135° or more), and do

not apply excessive pressure to the LCD. Also, do not hold the LCD

when opening or closing the display.

2 Turn your computer on.

Slide the power switch and hold it for approximately one second until the

power indicator turns on before releasing it.

z Do not slide the power switch and hold it for more than four seconds; this

will cause the power to be turned off forcibly.

z While booting, avoid the following until the hard disk drive indicator has

turned off.

• Connecting or disconnecting the AC adaptor.

• Touching the power switch.

• Performing any keyboard, touch pad, or external mouse operations.

• Closing the display.

• Sliding the open lever.

z Do not slide the power switch repeatedly.

z Once the computer is powered off, you must wait at least ten seconds

before powering it on again.

3 Log-on to Windows.

After confirming that the hard disk drive indicator has turned off, click the

user (user's icon).

z Input the password, then click . Until the correct password is entered,

the computer will not operate.

Confirm that character input is not set to “Caps Lock” or “NumLK.”

(Î page 16)

z This operation may differ according to [Use the Welcome screen] setting

(Î page 41).

z When only one user has been created and no password has been set, the

screen for selecting the user will not be displayed (automatic log-on).

4 Select your application.

Run various software applications, etc. and operate them.

NOTE

z The power saving function is factory set, so if no key is pressed or if no device

has been accessed for a certain interval of time:

• The power to the LCD and hard disk may be turned off. The LCD will resume

operation when the touch pad or an external mouse (when one is connected)

is used or a key is pressed.

The power to the LCD may be turned off even when an application software is

being installed. In this case, because it is conceivable that a selection dialog

box will be shown, do not press the

Space

key or the

Enter

key to attempt

to resume from this condition as doing so may trigger a selection, but instead,

press a key unrelated to the direct triggering of a selection, like the

Ctrl

key.

In addition, when the computer is left alone, it automatically enters the standby

Starting Up

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Comments to this Manuals

No comments

Panasonic CF-W2 User Manual Page 23

Comments to this Manuals

Related products and manuals for Laptops Panasonic CF-W2