Panasonic PLCD15V Instruction Manual Page 1

PLCD15V 15-INCH TFT-LCD MONITOR INSTRUCTION MANUAL Please read this manual thoroughly before use, and keep it handy for future referen

INSTRUCTION MANUAL…………………………………………………………………………… 8 1. SELF-TEST DISPLAY When there is no connection at PC, the On Screen Display will show for 3 secon

9 …………………………………………………………………………… INSTRUCTION MANUAL : Screen : Brightness Increase or decrease the intensity of the image. : Contrast Increase or

: Audio : Volume Adjust audio volume. 11 …………………………………………………………………………… INSTRUCTION MANUAL

: OSD : H. Position Move the OSD position to right(▶) or left(◀). : V. Position Move the OSD position to up(▶) or down(◀). : Transparency Se

: Color (PC Mode) : Color Temp Adjust color temperature to 9300, 6500, user. (note : 9300 is factory default) : Red Adjust red color for user.

: Utility : Recall Select to reset all setting to the factory default values. : Lock Select ON or OFF (ON : Control key lock. OFF : Control

Wall mountable using two methods: 1) Using the 200 mm pre-cut holes 2) Using the VESA standard wall mount design and the 100mm hole pattern on t

▶ PIN ASSIGNMENTS ▶ ACCESSORY 1. POWER CORD 2. USER’S MANUAL 3. PC cable 4. Adaptor 5. Remote Control 6. Batteries 7. Wall mount (Option)

This monitor features a power management system to “power down” upon receipt of the VESA DPMS(The display power management signaling) from a VESA DPM

▶ LCD Type 15˝ Diagonal AM-TFT(Active-Matrix) Pixel pitch (mm) : 0.297(H) 0.297(V) BRIGHTNESS: 250cd/㎡(Typical) CONTRAST RATIO:600:1(Typical) RE

SAFETY INSTRUCTION…………………………………………………………………….2 - 3 CAUTIONS ………………………………………..……………………………………………..4 FCC RF INTERFERENCE STATEMENT ……………………………………………………

WEEE Symbols 19 …………………………………………………………………………… INSTRUCTION MANUAL “Going to Sleep” message on screen Correct Disposal of This

Important Safety Instruction 1. Read these instructions. 2. Keep these Instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not

“WARNING - To reduce the risk of fire or electric shock, do not expose the apparatus to rain or moisture.” “The apparatus shall not be exposed

CAUTIONk The power supply cord is used as the main disconnect device, ensure that the socket-outlet is located/installed near the equipment and is ea

NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim

A. BOTTOM PANEL CONTROL 1. DC 12V IN 2. D-SUB IN PC Signal Input 3. VIDEO 1(AV1) IN Composite signal Input for AV1 4. VIDEO 1(AV1) OUT Video l

B. REMOTE CONTROLLER 1. POWER( ) Turns the power ON or OFF. There will be a few seconds delay before the display appears. 2. SOURCE Select pc or vid

1. SOURCE Select input source, and move the previous menu. 2. MENU Activates and exits the On Screen Display. This button can also be used to move