Panasonic Toughpad FZ-A2 User Manual download pdf (Page 13)

Read Me First

For U.S.A.

Federal Communications Commission

Radio Frequency Interference Statement

Note: This equipment has been tested and

found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful in-

terference in a residential installation. This

equipment generates, uses and can radiate

radio frequency energy and, if not installed

and used in accordance with the instructions,

may cause harmful interference to radio com-

munications. However, there is no guarantee

that interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television re-

ception, which can be determined by turning

the equipment off and on, the user is encour-

aged to try to correct the interference by one

or more of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment

and receiver.



Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.



Consult the Panasonic Service Center or

an experienced radio/TV technician for

help.

Warning

To assure continued compliance, use only

shielded interface cables when connecting to

a computer or peripheral. Also, any changes

or modiﬁ cations not expressly approved by

the party responsible for compliance could

void the user’s authority to operate this equip-

ment.

FCC RF Exposure Warning:



This equipment is provided with PC Card

slot that could be used with wireless trans-

mitters, which will be speciﬁ cally recom-

mended when they become available.



Other third-party wireless transmitters

have not been RF exposure evaluated for

use with this computer and may not com-

ply with FCC RF exposure requirements.



This equipment complies with FCC radia-

tion exposure limits set forth for an uncon-

trolled environment.



This equipment may not be collocated or op-

erated with any other antenna or transmitter.



This device meets the government’s re-

quirements for exposure to radio waves.

This device is designed and manufactured

not to exceed the emission limits for expo-

sure to radio frequency (RF) energy set by

the Federal Communications Commission

of the U.S. Government.



The exposure standard for wireless device

employs a unit of measurement known as

the Speciﬁ c Absorption Rate, or SAR. The

SAR limit set by the FCC is 1.6

W/kg



* Tests for SAR are conducted using stan-

dard operating positions accepted by the

FCC with the device transmitting at its

highest certiﬁ ed power level in all tested

frequency bands.

Although the SAR is determined at the

highest certiﬁ ed power level, the actual

SAR level of the device while operating

can be well below the maximum value.

This is because the device is designed

to operate at multiple power levels so as

to use only the poser required to reach

the network. In general, the closer you

are to a wireless base station antenna,

the lower the power output.

This product is restricted to indoor use due

to its operation in the 5.15 to 5.25

GHz

fre-

quency range. FCC requires this product to

be used indoors for the frequency range 5.15

to 5.25

GHz

to reduce the potential for harm-

ful interference to co-channel Mobile Satellite

systems. High power radars are allocated as

primary users of the 5.25 to 5.35

GHz

and

5.65 to 5.85

GHz

bands. These radar stations

can cause interference with and/or damage

this product.

25-M-W-1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Panasonic Toughpad FZ-A2 User Manual Page 13

Comments to this Manuals

Related products and manuals for PDAs Panasonic Toughpad FZ-A2