Panasonic TH-65PF30U Operations Instructions download pdf (Page 27)

H-POS Adjust the horizontal position. V-POS Adjust the vertical position.

H-SIZE Adjust the horizontal size. V-SIZE Adjust the vertical size.

DOT

CLOCK

(During Component/PC input signal)

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,

adjust so that any such noise is minimized.

CLOCK

PHASE

(During Component/PC input signal)

Eliminate the  ickering and distortion.

OVER

SCAN

Turn image over scan ON/OFF.

Con gurable signals are as follows:

525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)

ON OFF

Notes:

• When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.

• When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 55)

Adjusting POS./SIZE

Notes:

• If the dot clock frequency of an analog signal is 162 MHz or higher, “DOT CLOCK” and “CLOCK PHASE”

cannot be automatically corrected.

• When digital signal input, DOT CLOCK and CLOCK PHASE cannot be made.

• AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright image

with borders and other objects are clearly shown, and then try auto setup again.

• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out  ne tuning for the

position/size as required.

• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,

1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page

50) may results in correct AUTO SETUP.

• AUTO SETUP does not work well when a signal such as additional information is superimposed out of

valid image period or intervals between synchronizing and image signals are short, or for image signal with

tri-level synchronizing signal added.

• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION (

) then adjust

POS./SIZE manually.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 71 72

No comments

Panasonic TH-65PF30U Operations Instructions Page 27