Panasonic WJ-DR200 User Manual

AV Disc RecorderWJ-DR200Before attempting to connect or operate this product, please read these instructions carefully.ENGLISHFRANÇAIS

WJ-DR200 Setup MenuVIDEO INPUT-8-SYSTEM CONNECTIONS Basic SystemShown below is a typical connection scenario.CAUTION- FOR CONTINUED PROTECTIONManufac

DefaultWJ-FS616 Setup MenuSYSTEM SETUP 2/2SYSTEM SETUP 2/2REC MODE SETUPWJ-FS616 SETUP MENUSYSTEM SETUP 1/2ALARM SETUPItemVCR IN SELECTREC/MULTI 2SEQ

-10- Terminal BoardThe Terminal Board has the following functions. Makeconnections to these terminals as needed for operatingyour system. GND termi

-11- External Remote Control● Parallel Control PortConnect an external remote control switch to the PARALLEL CONTROL port on the rear of the Disc Rec

-12-● Serial Control PortConnect a personal computer to the SERIAL CONTROL port on the rear of the Disc Recorder. This port conforms bothwith the RS-

-13-● Series Recording 2(Alternate Time Lapse Recording)Connect the terminals on the Terminal Boards of the MASTER and SLAVE Recorder as shown below.W

-14-SETUP PROCEDURESThe Setup Menu provides a way for controlling functionsnot available through direct input.● Displaying the SETUP MENU1. Confirm th

-15- MAIN MenuAs shown below, the MAIN menu has seven main submenus: Set Up, System, Recording Mode 1, Recording Mode 2, AlarmRecording, Search/Play,

-16- SET UP MenuThis menu lets you change the setup or register an upto 8-character password that will allow you access tothe setup menu.

-17-2. Select the desired mode by pressing the or button.MANUAL: Selects manual recording mode.ALARM REC: Selects Alarm Recording mode.DISC AND ALARM

Warning:This equipment generates and uses radio frequency ener-gy and if not installed and used properly, i.e., in strictaccordance with the instructi

-18-A (CAMERA ID ON): Records only input A withmultiplexed Camera ID signals.Use this parameter when the Disc Recorder isconnected to a Video Multipl

-19-● Series Recording SetupThis item lets you designate the master and the slaverecorder when more than one Disc Recorder is used forseries recording

-20-To change a parameter in the REC MODE menu:1. Move the cursor to the desired item parameter bypressing the or button.2. Select the desired paramet

AUDIO OFF-21- MULTI SHOT(MODE1) CAPTURE RATE 0.20 sec RECORD FRAMES 2 ( 0.4sec) PRE/POST FRAMES 0 /2 REC PATTERN

-22-2. Select either pattern by pressing the or but-ton.SAME AS ALARM: Same recording pattern asfor alarm activationDIFF FROM ALARM: Different recor

-23-● Recording PatternWhen the CAMERA INPUT parameter in the VIDEOINPUT menu is set to A+B (CAMERA ID OFF), thisitem lets you select recording of pre

-24-● Auto Start SetupThis item lets you enable or disable automatic TimeLapse Recording, when the Disc Recorder’s power isturned on.1. Move the curso

-25-● Capture RateThis item lets you specify the interval (seconds) forrecording of multiple freeze pictures.1. Move the cursor to the CAPTURE RATE p

-26- MAIN SET UP ENABLE SYSTEM * REC MODE MODE1 * MODE2 * ALARM R

-27-1. Move the cursor to the PROGRAM TIMER parameterin the ALARM RECORD menu by pressing the or button.2. Select either ON or OFF by pressing the or

-1-The WJ-DR200 AV Disc Recorder can record up to28,000 freeze pictures with a resolution of 720 x 480(Fine Mode) on a large capacity optical disc (DV

-28- MAIN SET UP ENABLE SYSTEM * REC MODE MODE1 * MODE2 * ALARM R

-29-LOOP: Repeats playing back the selected numberof playback records.SINGLE CYCLE: Goes on standby after playingback the selected number of records.T

-30- MAIN SET UP ENABLE SYSTEM * REC MODE MODE1 * MODE2 * ALARM R

-31-3. Move the cursor on the desired character in thetable by pressing the , , or button.4. Press the SET button to pick up the character, andpla

-32- LOGICAL FORMAT FORMAT PASSWORD * VOLUME LABEL * DISC PASSWORD * START : PRESS SET KEY2 Move the cursor to the

-33- SET_UP PASSWORD A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9 0 CLEAR ENTER

-34-FORMATTING THE DISCThe DVD-RAM Disc requires formatting before it can beused for storing data. Follow the procedures describedbelow to format the

-35-● Physical Format MenuThis menu lets you perform physical formatting of theDVD-RAM Disc after logical formatting. The processinvolves checking of

-36-RECORDING Recording ModesThe WJ-DR200 Disc Recorder has three recordingmodes to match your specific needs.Refer to the Recording Mode Menu on pag

-37-3. The recorder repeats procedure 2 until the ALARMREC STANDBY button is pressed.4. To stop alarm recording, press the ALARM RECSTANDBY button. S

-2-PRECAUTIONS• Refer all work related to the installation of thisproduct to qualified service personnel or systeminstallers.• Do not block the ventil

-38-3. Load a write enabled disc to all recorders, thenpress the REC button of the MASTER recorder.The MASTER recorder starts recording in TimeLapse R

-39-PLAYBACK Basic PlaybackThe recorder has the following two basic playback func-tions.Playback/Reverse PlaybackPlays back the record recorded last

-40-● Forward/Reverse Single Frame PlaybackPress the (or ) button in paused playback.(or ) is displayed in the lower center ofthe monitor screen, an

-41-Note: Pressing the (or ) button for about 2seconds in step 2 will skip forward (or back-ward) by the number of records specified for theSKIP#RECO

-42-3. Select the password in the menu, then press theSET button to display the Deny Access setup menuas shown below. NO RECORD TIME 0

● Time Lapse Recording TimeNote: Time Lapse recording time varies slightly depending on the images recorded.1. Without Audio (for a 20-partition disc)

CAPTURERATECAPTURERATE-44-0.030.070.100.170.200.330.50123451015202530Audio ONPixel Number 720 ∗ 480FINE NORMAL ROUGHAudio OFFFINE NORMAL ROUGH0:30 0:4

-45- Checking Your PasswordIf you have forgotten your password, you can look it upas follows. MAIN SET UP DISABLE

-46- Cleaning the DVD DriveThe DVD drive needs to be cleaned after prolongeduse.Use the optional cleaning disc as shown below forcleaning the drive.

V OH = 11 - 13 V (4 700 Ω)V OL = 0 - 0.6 V (3.0 mA max.)V OH = 5±0.5 V (200 Ω)V OL = 0 - 0.6 V (3.0 mA max.)AlarmRecoverOutput-47-GeneralPower Source:

-3-1. Operate indicator (OPERATE)Is on (green) when the Disc Recorder’s power isturned on.2. Remote indicator (REMOTE)Is on (orange) when the Disc Rec

-48-STANDARD ACCESSORYAC Power Cord ...1 pc.

NM1098-4041 YWV8QA5023EN Printed in JapanN 19 Imprimé au JaponSecurity and Digital Imaging Systems CompanyA Division of Matsushita Electric Corporatio

-4-13. Eject holeFor sliding out the disc tray manually (by inserting awire) if it is not ejected automatically when pressingthe OPEN/CLOSE button (35

-5-CAUTION- FOR CONTINUED PROTECTIONManufactured by Matushita CommunicationIndustrial Co. Ltd Yokohama Japan- AFIN D' ASSURER UNEATTENT

-6-54. Cooling fanPrevents temperature rise inside the unit.55. AC socketFor connecting the supplied power cord.56. Power switch (POWER ON/OFF)Turns t

-7-INSTALLATIONSThe installations described below should be made by qualified service personnel or system installers.3. Install the Disc Recorder with