Panasonic SC-HTB10EG-K Operations Instructions download pdf (Page 17)

Operating Instructions

If the “ D/DTS” indicator is blinking, unplug

the AC power supply cord and consult your

dealer.

If the “TV, BD/DVD” indicator is blinking, try the

following to correct the problem. Consult your

dealer if the problem persists.

≥ Turn the connected device off and on again.

≥ Turn this unit off and reconnect the HDMI cables

and then turn this unit on again.

If this unit is connected to a non-Panasonic

ARC compatible TV, connect using an optical

digital audio cable. (> 10)

≥ After connecting the optical digital audio cable,

the setting of this unit must be changed to specify

the audio input terminal. (> right, “TV Audio”)

Audio is output from the TV speakers and not

this unit’s.

≥ When connected to a VIERA Link (HDAVI

Control) compatible TV, change the audio output

settings to this unit. (> 14)

Refer to “Troubleshooting” (> 16) before

changing any of the following settings.

The settings remain intact even if you switch the

unit to standby mode.



A will blink green once when the setting is changed.

∫ VIERA Link

Changes to this setting become effective after

turning off and on all the connected devices.

Set “VIERA Link” to “Off”.

Set “VIERA Link” to “Off” when you do not want to

use “HDAVI Control”. (> 16, “General operation”)

Press and hold [INPUT SELECTOR] on this

unit and [BD/DVD] on the remote control for

more than 2 sec.

≥ When set to “Off”, the ARC function is not

available. Be sure to connect using the optical

digital audio cable. (> 10)

Set “VIERA Link” to “On”.

Press and hold [INPUT SELECTOR] on this

unit and [SOUND EFFECT] on the remote

control for more than 2 sec.

∫ TV Audio

Set “TV Audio” to “ARC Off”.

Set “TV Audio” to “ARC Off” only when using an

optical digital audio cable with an ARC compatible

TV. (> 16, “Sound”)

Press and hold [INPUT SELECTOR] on this

unit and [TV] on the remote control for more

than 2 sec.

Set “TV Audio” to “Auto”.

Press and hold [INPUT SELECTOR] on this

unit and [CLEAR-MODE DIALOG] on the

remote control for more than 2 sec.

When other Panasonic products respond to this

unit’s remote control, change the remote control

code on this unit and the remote control.

Preparation

≥ Turn off all other Panasonic products.

≥ Turn on this unit.

Change the remote control to code 2:

1 Aim the remote control at this unit’s remote

control sensor.

2 Press and hold [CLEAR-MODE DIALOG] and

[BD/DVD] on the remote control for more than

4sec.

A will blink green once when the code of this unit is

changed.



≥ If the unit does not operate after changing the code, repeat

steps 1 and 2.

≥ To change the remote control to code 1, repeat the steps

above, but replace [BD/DVD] with [TV].

Changing this unit’s

settings

Remote control code

SCHTB50_10PPC_RQTX1165-P.book Page 17 Monday, May 10, 2010 11:58 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Panasonic SC-HTB10EG-K Operations Instructions Page 17

Comments to this Manuals