Panasonic E9RKUA Operations Instructions download pdf (Page 10)

The following symptoms do not indicate malfunction.

Symptom Cause

Mist emerges from indoor unit. • Condensation effect due to cooling process.

Water ﬂ owing sound during operation. • Refrigerant ﬂ ow inside the unit.

The room has a peculiar odour. • This may be due to damp smell emitted by the wall,

carpet, furniture or clothing.

Indoor fan stops occasionally during automatic

fan speed setting.

• This helps to remove the surrounding odour.

Airﬂ ow continues even after operation has

stopped.

• Extraction of remaining heat from the indoor unit

(maximum 30 seconds).

Operation is delayed a few minutes after

restarting.

• The delay is a protection to the unit’s compressor.

Outdoor unit emits water/steam. • Condensation or evaporation occurs on pipes.

TIMER indicator is always on. • The timer setting repeats daily once set.

POWER indicator blinks during HEAT mode

with no warm air supply (and ﬂ ap is closed).

• The unit is in defrost mode (and AIR SWING is set to

AUTO).

Indoor fan stops occasionally during heating

operation.

• To avoid unintended cooling effect.

POWER indicator blinks before the unit is

switched on.

• This is a preliminary step in preparation for the

operation when the ON timer has been set.

Cracking sound during operation. • Changes of temperature caused the expansion/

contraction of the unit.

Discoloration of some plastic parts. • Discoloration is subject to material types used in plastic

parts, accelerated when exposed to heat, sun light, UV

light, or environmental factor.

Check the following before calling for servicing.

Symptom Check

Operation in HEAT/COOL mode is not working

efﬁ ciently.

• Set the temperature correctly.

• Close all doors and windows.

• Clean or replace the ﬁ lters.

•

Clear any obstruction at the air inlet and air outlet vents.

Noisy during operation. • Check if the unit has been installed at an incline.

• Close the front panel properly.

Remote control does not work.

(Display is dim or transmission signal is weak.)

• Insert the batteries correctly.

• Replace weak batteries.

The unit does not work. • Check if the circuit breaker is tripped.

• Check if timers have been set.

The unit does not receive the signal from the

remote control.

• Make sure the receiver is not obstructed.

• Certain ﬂ uorescent lights may interfere with signal

transmitter. Please consult authorised dealer.

Troubleshooting

NON SERVICEABLE CRITERIAS

SWITCH OFF POWER AT THE CIRCUIT BREAKER then please consult an authorised dealer under

the following conditions:

• Abnormal noise during operation.

• Water/foreign particles have entered the remote

control.

• Water leaks from Indoor unit.

• Circuit breaker switches off frequently.

• Switches or buttons are not functioning properly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Panasonic E9RKUA Operations Instructions Page 10

Comments to this Manuals