Panasonic EY7840 User Manual download pdf (Page 10)

-

10

-

CAUTION:

• The built-in LED light is designed to

illuminate the small work area tem-

porarily.

•

Do not use it as a substitute for a

regular

flashlight, since it does not

have enough brightness

.

This product has the built-in LED light.

This product is classified into “Class 1

LED Product” to IEC (EN) 60825-1:2001.

LED RADIATION

DO NOT STARE INTO BEAM

CLASS 1 LED PRODUCT

Use of controls or adjustments or perform-

ance of procedures other than those speci-

ed herein may result in hazardous radiation

exposure.

(2) Overheat warning lamp

Off

(normal

operation)

Flashing: Overheat

Indicates operation has

been halted due to battery

overheating.

The overheating protection feature

halts tool operation to protect the

b

attery pack in the event of over-

heating. The overheat warning lamp

on the control panel flashes when

this feature is active.

•

If the overheating protection feature

activates, allow the tool to cool

thoroughly (at least 30 minutes).

The driver is ready for use when the

overheat warning lamp goes out.

•

Avoid using the tool in a way that

causes the overheating protection

feature to activate repeatedly.

(3)

Battery low warning lamp

Off

(normal

operation)

Flashing

(No charge)

Battery protection

feature active

The battery protection feature acti-

vates immediately before the battery

loses its charge, causing the battery

low warning lamp to flash.

•

If you notice the battery low warning

lamp flashing, charge the battery

pack immediately.

Installing the Shoulder Strap

CAUTION:

• Install the shoulder strap firmly to

the main unit of the tool and check

the length of the strap before use.

•

Check the condition of the strap

and do not use if it is cut or torn

etc.

There

is a risk of injury or damage

if used while improperly installed.

•

Please wear the shoulder strap se-

curely on the shoulder.

There

is a risk of injury or damage

if it is accidentally dropped.

1

. Pass the strap through the strap

holders. (

)

2. Pass the strap through the buckles

and adjust the length. (

)

Shoulder pad

• The shoulder strap can be adjusted

according to the individual.

• Adjust the shoulder pad to the

shoulder.

•

Pull the shoulder strap to make

sure it is firmly attached to the main

unit of the tool.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments