Panasonic MCE4063K Operations Instructions download pdf (Page 14)

TROUBLE SHOOTING GUIDE

Before contacting your Pansonic service centre, check the following points:

NOTE: Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a charge if referred

to a service agent for attention.

CAUTION:DISCONNECT from the mains socket before carrying out any kind of maintenance opera-

tion.

TROUBLE CHECK POINT CAUSE / REMEDY

Motor fails to rotate • Mains plug connection • Check that the mains plug is connected firmly and

(no noise is heard at all) mains socket is ON.

• Mains plug fuse. (UK, IRL only) • Check fuse and replace if blown.

• Thermal cut-out device may have • (See Thermal cut-out protection feature below

operated. described).

Motor runs but there • Hose inlet is blocked. • If there is a blockage, remove it.

is no suction. see (BLOCKAGES)

• Check dust mark. • If it shows full, empty the dust bin.

• Primary filter • If the primary filter is full of dust, clean it or

replace. (see FILTER CARE)

• Check hose is properly inserted • Re-insert the hose to suction pipe inlet correctly.

to the suction pipe inlet.

• Check dust accumulated on primary • Remove dust accumulated or replace the filters.

filter. (see FILTER CARE)

• Exhaust filter. • If exhaust filter is full of dust, clean or replace it.

(see FILTER CARE)

• Dust bin inlet is blocked. • If there is a blockage, remove it.

(see BLOCKAGES)

Beater bar does not • Clogged by a large object in • If there is any obstruction, remove it.

rotate. the beater bar housing.

• Belts broken or loose. • If the belt is broken, replace it.

If loose re-install it.

THERMAL CUT-OUT

This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the vacuum cleaner to prevent over-

heating of the motor. When this happens, disconnect the vacuum cleaner from the mains socket and check the dust bin and fil-

ters as it may be full or clogged with fine dust. Check for any other obstructions.

After emptying the dust bin or removing the obstruction, leave the vacuum cleaner to cool down until the thermal cut-out resets

after approximately 40 minutes.

IMPORTANT: The thermal cut-out will not reset if the vacuum cleaner is not disconnected from the mains socket.

MAINS LEAD

IMPORTANT: If the mains lead becomes damaged, it must be repaired by Panasonic, authorised service centre or a

qualified person in order to avoid any hazard.

1 2 ... 9 10 11 12 13 14 15 16 17 18

No comments

Panasonic MCE4063K Operations Instructions Page 14