Panasonic MCE590 Operations Instructions download pdf (Page 13)

– 13 –

TROUBLE SHOOTING GUIDE

TROUBLE

Motor fails to rotate

(no noise is heard

at all).

Motor runs but

there is no suction.

Beater bar does not

rotate.

Cord reel does not

rewind properly.

(except MC-E590)

Dust sensor

(MC-E593 only)

(RED light does not

light even if the

carpet is dirty).

Pre-filter wiper

does not turn.

CHECK POINT

• Mains plug connection.

• Mains plug fuse. (UK, IRL only)

• Thermal cut out device may

have operated.

• Hose inlet is blocked.

• Check dust mark.

• Pre-filter

• Central filter.

• Check hose is properly inserted

to the suction pipe inlet.

• Check dust accumulated on

main filter.

• Clogged by a large object in the

beater bar housing.

• Over current cut-out may have

operated.

• Check beater bar pedal is in

"OFF" position.

• Thermal cut out device may

have operated.

• Cord may be twisted.

• Cord may be dirty.

• Hose inlet is clogged.

• Check for any possible blockage.

• Check the pre-filter wiper is not

trapped underneath itself.

• Check dust accumulated on

main filter.

POSSIBLE SOLUTION

• Check that the mains plug is connected firmly

and mains socket is ON.

• Check fuse and replace if blown.

• (See protection features).

• If there is a blockage, remove it.

• If it shows full, empty the dust compartment.

• If the pre-filter is full of dust, clean it.

• If the central filter is full of dust, clean or

replace it.

• Re-insert the hose to suction pipe inlet

correctly.

• Remove dust accumulated or replace the

filter. (see page 10 FILTER CARE)

• If there is any obstruction, remove it and

press the reset button to reactivate the beater

bar motor.

• (See protection features)

• Press the pedal to the "ON" position.

• (See protection features)

• Pull out the power supply cord fully and

rewind it again.

• Wipe the cord clean with duster.

• Find the blockage and remove it.

• Remove the obstruction.

• Rotate the pre-filter wiper in an anti-clockwise

direction until it untangles.

• Remove dust accumulated or replace it.

(see page 10 FILTER CARE)

NOTE: If the flexible power supply cord becomes damaged, it must be repaired by Panasonic, or

an Authorised Service Centre or a qualified person in order to avoid any hazard.

CAUTION: Disconnect from the mains socket before carrying out any kind of maintenance operation.

Before returing the vacuum cleaner to a Panasonic Service Centre, check the following points:

Pre-filter

wiper

Pre-filter wiper

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Panasonic MCE590 Operations Instructions Page 13

Comments to this Manuals

Related products and manuals for Vacuum cleaner supplies Panasonic MCE590