18
■ Serial Port Connections
● RS232C Connection
A 9-pin connector is provided with the recorder to communicate with the PC based on the RS232C.
● PS
•
Data Connection
Note the following when connecting the recorder with the PS
•
Data devices.
1. Place the recorder in the middle of the chain when the System Controller and other devices are connected.
2. Termination must be made at both ends of the chain.
Refer to the manual included with each device for termination.
See page 20, ■ DATA Port Termination for the recorder.
3. Protocol selection must be set to PS
•
DATA in the menu setup.
4. Use the optional RS-485 cable for connection.
Connection examples are shown.
<Case 1 > With System Controller and other devices
Comments to this Manuals