Panasonic DMRBCT84EN Operations Instructions download pdf (Page 103)

Troubleshooting

SQT0351

103

3D video is not output correctly.

• 3D video may be output correctly by changing

the following settings:

- “3D Type” of “3D Settings” (> 90)

- “Signal Format” (> 49, 3D settings during

playback)

• Check the settings of the connected TV.

• When a non-3D compatible amplifier/receiver is

connected between this unit and a TV, 3D video

is not output. (> 17)

• When the amplifier/receiver which is connected

between this unit and a TV is off, 3D video is not

output. (> 17)

• 3D discs may not be played back correctly due

to the settings of the TV.

• When “HDMI Audio Output” is set to “Off”, 3D

video may not be output correctly. (> 91)

No sound.

Distorted sound.

• Check the connections. (> 16)

• Check the settings of the connected TV, etc.

• Press [AUDIO] to select the audio. (> 27, 48)

• To output audio from a device connected with an

HDMI cable, set “HDMI Audio Output” to “On”.

(> 82, 91)

Cannot change audio channel.

• You cannot change the audio channel if “Digital

Audio Output” is set to “Bitstream” (> 88)

Cannot record.

Cannot copy.

• Some broadcasts are copyright protected.

• You cannot record to the disc by pressing the

[REC ¥] or timer recording.

• The disc is protected. (> 97)

• [DVD-R] [DVD-RW] [+R] [+RW] Since it will copy to

HDD temporarily, copying is not possible if there

is insufficient available capacity on the HDD.

• [DVD-R] [DVD-RW] [+R] [+RW] Copying or editing

may not be possible on these discs after

ejecting and loading the disc or switching the

unit on or to standby mode for approximately

30 times after being copied to.

• This unit cannot record/copy NTSC signals to

discs that already have PAL signal recordings.

The same video is displayed in each left and

right half of the screen.

• This is a 3D programme of the Side-by-Side

type.

Change the setting as follows if connecting with

a 3D compatible TV:

1 Press [OPTION].

2 Select “Playback Settings” in “Playback

Menu”, then press [OK].

3 Select “3D Settings”, then press [OK].

4 Select “Side by side” in “Signal Format”, then

press [OK].

Sound

Recording, timer recording and

copying

Timer recording does not work properly.

• Failed timer recordings are displayed in grey

with on the Timer Recording screen. (> 37)

When you programme a timer recording, check

the screen icons. If “!” is displayed, this timer

programme may not be recorded because:

- there is not enough space left.

- the number of possible titles has reached its

maximum.

- programmes are deactivated, etc.

• If your CAM requires a PIN for timer recording,

you need to enter PIN in advance. (> 86, PIN

Entry for Decrypt Recording)

Auto Renewal Recording does not work

properly.

• The programme will not be overwritten in the

following cases:

- the programme is protected

- any programme is being played back or copied

- a screen such as DIRECT NAVIGATOR is

displayed

Instead, the programme will be saved as a

separate programme and that will be

overwritten.

DMR-BCT84_74EN_eng.book 103 ページ２０１４年７月２４日　木曜日　午後５時３分

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 119 120

Comments to this Manuals

No comments