Panasonic PV-GS80 User Manual download pdf (Page 14)

Before using

Power supply

Connecting to the AC outlet

I Charging the battery

When this product is purchased, the battery is not

charged. Charge the battery before using this

product.

• Battery charging time, {-is-)

•We recommend using Panasonic batteries.

(.//., -72-)

• If you use other batteries, we cannot guarantee

the quality of this product.

• If the DC Cable is connected to the AC adaptor,

then the battery will not get charged. Remove

the DC Cable from the AC adaptor.

1 Connect the AC Cable to the AC adaptor

and the AC Jack.

2 Put the battery on the battery mount by

aligning the mark, and then securely plug it

in.

I Charging lamp

Lights up: Charging

Goes off: Charging completed

Flashing: The battery is over discharged

(discharged excessively). In a while,

the lamp will light up and normal

charging will start.

When the battery temperature is

excessively high or low, the [CHARGE]

lamp flashes and the charging time will

be longer than normal.

CAUTION

Danger of explosion if battery is incorrectly

replaced. Replace only with the same or

equivalent type recommended by the

manufacturer. Dispose of used batteries

according to the manufacturer’s instructions.

1 Connect the AC Cable to the AC adaptor

and the AC Jack.

2 Connect the DC Cable to the AC adaptor.

3 Connect the DC Cable to this product.

• The output plug of the AC Cable is not

completely connected to the AC adaptor jack.

As shown in 0> there is a gap.

• Do not use the power cord for other

equipment since the power cord is exclusively

designed for this Camcorder. Do not use the

power cord from other equipment for this

Camcorder.

■ Attaching the battery

Push the battery against the battery holder and

slide it until it clicks.

■ Removing the battery

While sliding the [BATTERY] lever, slide the

battery to remove it.

• Hold the battery with your hand so it does not

tali.

• Before removing the battery, be sure to set the

[OFF/ON] switch to [OFF].

14

LSQT1121

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 80 81

Comments to this Manuals

No comments