Panasonic PVGS500 Operations Instructions download pdf (Page 39)

Record mode

39

LSQT0975

Adjusting the Microphone Sensitivity

Level

When recording, the input level from the built-in

microphone and the external microphone terminal

can be adjusted.

≥Set to Tape Recording/Playback Mode.

1 Set [ADVANCED] >> [MIC LEVEL] >>

[AUTO], [SETrAGC] or [SET].

AGC*: Auto Gain Control

[AUTO]: AGC is activated, and the recording

level is adjusted automatically.

[SETrAGC]:The desired recording level can be

set. AGC will also be activated to

reduce the amount of sound

distortion.

[SET]: AGC is not activated and so natural

recording can be performed. Adjust

in such a way that the sound will not

be distorted at the maximum volume

level.

2 Move the joystick left or right to increase or

decrease the bars of the gain value.

3 Press the joystick to determine the setting.

≥Adjust the gain value so that the last 3 bars of

the [ ] on the center of the screen will not light

red. (Otherwise, the sound is distorted.) Select a

lower setting for gain value or set [MIC LEVEL]

to [AUTO].

≥The [MIC LEVEL] ([AUTO], [SETrAGC] or

[SET]) setting on the Tape Recording/Playback

Mode will be the same.

(Microphone sensitivity level can be adjusted on

each mode separately.)

≥When [ZOOM MIC] is set to [ON], set the zoom

to the [T] position before performing this

adjustment.

Auto Ground-Directional Standby

(AGS)

This function prevents unnecessary recording

when you forget to pause recording and walk with

the Camcorder tilted upside down while recording

continues.

≥If the Camcorder continues to be tilted upside

down from the normal horizontal position while

recording on a tape, it is automatically put into

recording pause.

[AGS]: Auto Ground-Directional Standby

≥Set to Tape Recording Mode.

Set [SETUP] >> [AGS] >> [ON].

ª

To cancel Auto Ground-Directional

Standby

Set [SETUP] >> [AGS] >> [OFF].

≥The AGS function may activate and cause the

Camcorder to pause the recording if you are

recording a subject right above or right below

you. In these cases, set [AGS] >> [OFF] then

continue the recording.

≥Use the recording start/stop button to pause or

stop the recording. The AGS function is only a

backup function for when you forget to pause

the recording.

≥The time it takes the Camcorder to be put into

recording pause after being tilted upside down

varies depending on the operating conditions.

LSQT0975_ENG.book 39 ページ２００５年１２月１９日　月曜日　午前９時５１分

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 95 96

Comments to this Manuals

No comments