Panasonic WV-BP550 User Manual download pdf (Page 31)

-29-

1. Move the cursor to the LENS DRIVE parameter.

2. Select DC if you are using the auto iris lens that

requires a DC drive signal.

Select VIDEO if you are using the auto iris lens that

requires a video drive signal.

8. Lens Drive Signal Selection (LENS

DRIVE)

This item is used to select the type of auto iris lens

drive signal to be supplied to the lens from the auto iris

lens connector.

** CAM SET UP **

CAMERA ID OFF

ALC/ELC ALC

SHUTTER ---

AGC ON

SENS UP OFF

SYNC INT

MOTION DET OFF

LENS DRIVE DC

END SET UP ENABLE

↵↵↵

6. To raise detection sensitivity, press to return to

the MOTION DETECT menu.

7. To obtain the optimum detection level, move the

“I” cursor to adjust the level.

8. Repeat the procedures above to obtain a satisfac-

tory setting.

9. Move the cursor to RET and press to return to

the CAM SET UP menu.

Notes:

• Masking or adjusting the detection level is needed

to prevent malfunction under the following condi-

tions:

• When shooting an object under flickering fluores-

cent light or shooting in ELC.

• When leaves or curtains etc. are swayed by the

wind.

• When the object is lighted by lighting equipment

that constantly turns on and off.

• It takes about 0.2 seconds for the alarm signal to

reach the alarm terminal of the VCR after the cam-

era detects the object.

Because the alarm signal is multiplexed on the

video signal, it may be mistakenly interpreted by

other video equipment as a time code signal.

Therefore, when camera is not used in a

Panasonic Intelligent CCTV System select OFF to

prevent the above from occurring.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Panasonic WV-BP550 User Manual Page 31

Comments to this Manuals

Related products and manuals for Cameras Panasonic WV-BP550