Panasonic NE-3280 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Hoyiiho^pperaXe
#2 or 3 stage heating
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see below on this page)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example: To program cooking at DEFROST power for 1 minute and at HiGH power for 2 minutes into Memory pad “5”
PAD
INSTRUCTION DIGnALDiSPUY WINDOW
-wS-
t n n
‘i:-
t uu
tTA6t
Follow steps 1 to 5 on page 10.
Ih..
POWER
Press Power Level Selector pad once.
The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator “2" will start to blink.
Set the desired heating time using Timer Dial.
The set heating time will appear.
Note: up to 15 min. on HI or MED, 60 min. on LOW, DEF or HOLD
3
nn
c uu
8
O
PROG
Press Program Entry Button again.
^ “PROG” and 2nd Stage Heating Indicator “2” will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
moG
*5
3
nn
D U U
Three seconds later, Digital Display Window will go blank.
D. PROGRAM LOCK
To activate Program Lock:
PAD
INSTRUCTION
DlGrtAL DISPLAY WINDOW
1
Keep the door closed.
Digital Display Window must be blank.
2
o
PROGLOCK
Press Program Lock Button for five seconds until “PROG”, “P” and
“L” appear.
^ “PROG”, “P” and “L’ will appear.
«W! p ^
In Program Lock mode:
The oven is started by pressing the desired Memory pad. There is no need to press Start pad.
Opening the door cancels the remaining time on the program.
The oven can not be programmed until the program lock is released.
To release Program Lock:
PAD
INSTRUCTION
OIGrTAL DISPLAY WINDOW
Keep the door closed.
Digital Display Window must be blank.
o
PROGLOCK
Press Program Lock Button for five seconds until “PROG” and “P’
appear.
“PROG" and “P ” will appear.
In Program Unlock mode:
Oven reverts to a two-touch operating mode (Memory pad + Start pad).
Repeat and interrupt feature are operational.
Memory pads can be programmed.
Tone loudness and length can be changed.
- 11 -
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments