Panasonic TX55DXT686 Operations Instructions download pdf (Page 128)

Note

●

TV Guide may also be used to set timer event.

Watching > TV Guide > Timer Programming

●

Timer Programming can store up to 15 events.

●

Timer Programming only works reliably if correct time information is

received via the signal from the broadcaster or service provider.

●

For recording using Timer Programming, the TV must be either on or in

Standby.

●

No other channels can be selected while recording of Timer Programming

is in progress.

●

Recording an encrypted (copy-protected) programme may not be possible.

●

Depending on the network condition, recording function may not work

properly in DVB-via-IP.

●

When the start time comes, the channel will be switched automatically and

the video and audio signals will be output. 2 minutes before the start time,

a reminder message appears if you are watching TV.

– To remove the message and start the programming, press OK.

– To cancel the programming, press EXIT.

●

LED turns to orange in Standby mode when Timer Programming is set.

●

“!” identifies that two or more timer events are overlapped. As for the

overlapped recording events, the first event starts and finishes as

programmed. The next event can then start.

●

The recording of Timer Programming automatically changes the channel to

the programmed channel a few seconds before the start time.

●

For details of the USB HDD

Recording > Technical information

- 128 -

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 330 331

No comments

Panasonic TX55DXT686 Operations Instructions Page 128