Watching TV
21
Watching TV
Volume
Note
●
To watch pay-TV
“Using Common
Interface” (p. 65)
1
Turn power on
●
Press for about 1 second.
●
Mains power On / Off switch should be on. (p. 12)
■ VIERA Connect introduction banner appears
Every time you turn on the TV, this banner appears at the bottom of the
screen.
You can access to VIERA Connect easily and enjoy the various
contents. (p. 20)
●
To remove this banner, leave for about 5 seconds or press any
buttons (except the buttons to access VIERA Connect).
●
To set this banner display off [VIERA Connect Banner] (p. 46)
2
Select the mode
(freesat, DVB, Analogue or Other Sat. / Satellite)
●
You can also select the mode pressing the TV button repeatedly on the
remote control or the TV (p. 12).
TV Selection
freesat
DVB
Analogue
Other Sat.
Satellite
Displayed if [Other Satellite Auto
Setup] (p. 58) is completed.
select
access
●
The selectable modes vary depending on the selected
country and stored channels (p. 16).
3
Select a channel
up
down
or
freesat channel position numbers run in the ranges 100 - 999 and 0100 - 0999.
●
To select a three or four-digit channel position number, e.g. 0246
DVB and Other Sat. / Satellite channel position numbers run from 1 onwards.
Analogue channel position numbers run in the ranges 0 - 99.
●
To select a more than two-digit channel position number, e.g. 399
■ To select a channel using Information banner (p. 22)
It is possible to confirm the channel name and programme information by using the Information banner before
changing channels.
1 Display Information banner if it is not displayed
2 While the banner is displayed, select the channel
select channel
watch
■ To select a channel using TV Guide (p. 25)
It is possible to confirm the channel and programme information by using the TV Guide (EPG) before changing
channels.
1 Display TV Guide
2 Select the current
programme or channel
select
access
3 Select [View] (DVB)
Das Erste
19:30- 20:00
View
Timer Programming
select
watch
Comments to this Manuals