This antenna is normally sufficient for reception of AM broadcasts.
Fit the AM loop antenna holder (included) onto the rear panel of this
unit and then attach the AM loop antenna to the AM loop antenna
holder (facing in the direction of best reception).
Pay attention to the following points when mounting the antenna.
e Do not mount it close to power cords, speaker wires or metal sur
faces (Doing so will result in noise),
e Do not mount it dose to a tape deck. When the tape deck is being
used, chirping or beeping sounds may result.
Antenna connections
When mounting the antenna to a column, q wall or rack
Mount the antenna so that the hinge is vertical.
■
4»
£
Q>
QQ
m
Screw (included)
E
Vinyl-covered wire
(not included)
An outdoor antenna should be used when using this unit in moun
tainous areas or in spaces enclosed by reinforced concrete where
the AM loop antenna (included) does not provide satisfactory recep
tion.
Stretch 5 to 12 m of vinyl-covered wire horizontally across a window
frame or other convenient location, keeping it as high as possible
from the ground.
When the unit is not in use, disconnect the outdoor antenna to pre
vent possible damage that may be caused by lightning. Never use
an outdoor antenna during an electrical storm.
Be sure to connect the AM loop antenna even when AM outdoor
antenna is used.
Comments to this Manuals