Panasonic AG-DVC30 User Manual download pdf (Page 82)

82 (E)

Before calling for service (cont.)

I can’t hear any sound from the camera-

recorder’s speaker.

O Have you turned down the camera-recorder’s

volume control too far?

In the VCR mode, adjust the volume level

using the multi dial. (P49)

I can hear two sets of sound.

O Have you selected “MIX” as the 32K (12bit)

AUDIO item setting on the PLAYBACK

FUNCTION screen? (P73)

O If you perform audio dubbing on a tape that

was recorded with “32K (12bit)” selected as

the AUDIO REC item setting on the

RECORDING SETUP screen, you will hear

the sound heard during recording and that of

the audio dubbing. (P75)

When I performed audio dubbing on an

existing recording, the original sound was

erased.

O If you perform audio dubbing on a tape that

was recorded with “48K (16bit)” selected as

the AUDIO REC item setting on the

RECORDING SETUP screen, you will erase

the original sound on the tape. To leave the

original sound intact, make sure that “32K

(12bit)” is selected as the item setting when

you shoot the original recording. (P75)

Playback (sound)

I can’t remove the cassette tape.

O Is power still being supplied to the camera-

recorder? (Is the power from the AC adapter

and battery supplied properly?)

So long as the power is supplied, you can

remove the cassette even if the POWER

lever is at the OFF position.

I can remove the cassette but I can’t perform

any other operations.

O Has condensation formed?

If it forms, the only operation you can perform

is to remove the cassette. Wait until the

condensation has dried out. (P83)

O If the cassette cover is closed immediately

after sliding the EJECT switch to open the

cassette cover, you may no longer be able to

perform any operations other than eject.

If you did this, slide the EJECT switch again

to open the cassette cover, check that the

cassette mechanism has finished ejecting the

cassette, and then close the cassette cover.

The remote control unit does not work.

O Has the button battery in the remote control

unit run out?

If the remote control fails to work even when

it is operated near the camera-recorder’s

remote control sensor, it means that the

button battery has run out. Replace it with a

new one. (P24)

O Is the remote control setting the same for the

remote control unit and the camera-recorder?

If the REMOTE item setting does not

correspond between the two units, the

remote control unit will not work. (P24, P78)

I hear a rattling sound when I tilt the camera-

recorder back and forth.

O There are some parts in the structure of the

camera unit that make a rattling sound in the

VCR mode or when the POWER lever is at

the OFF position. This is not a sign that

something is broken.

Other

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 88

Comments to this Manuals

No comments