Panasonic HCV100EB Operations Instructions download pdf (Page 104)

104

VQT3Y11

When the status indicator is flashing at a

particularly fast or slow rate, the

following should be considered.

Flashing with approx. 4 second period

(off for approx. 2 seconds, on for approx.

2 seconds):

≥ When the battery is over discharged or the

temperature of the battery is too high or

low. It can be charged, but it may take a

few hours to complete the charging

normally.

≥ It will flash in approx. 2 second intervals

when normal charging resumes. Even in

such cases, it may start flashing in approx.

4 second intervals until charging is

completed depending on the conditions of

use.

Flashing with approx. 0.5 second period

(off for approx. 0.25 second, on for

approx. 0.25 second):

≥ The battery is not charged. Remove the

battery from the unit, and try charging

again.

≥ Check that the terminals of the unit or

battery are not dirty or covered with a

foreign object, and connect the battery

correctly once again. If a foreign object or

dirt is present, turn off the unit before

removing.

≥ The battery or environment is at an

extremely high or low temperature. Wait

until the temperature has returned to an

appropriate level and try charging again. If

you are still unable to charge, there may

be a fault in the unit, battery or AC

adaptor.

Off:

≥ Charging has finished.

≥ If the status indicator stays off despite the

charging being unfinished, there may be a

fault in the unit, battery or AC adaptor.

Refer to page 102 for details on the

battery.

When disposing of or giving away the SD

card, note that:

≥ Formatting and deletion of this unit or

computer only changes the file

management information and does not

completely delete the data in the SD card.

≥ It is recommended that the SD card is

physically destroyed or the SD card is

physically formatted using this unit when

disposing of or giving away the SD card.

For the physical format, connect the unit to

the AC adaptor, set the mode switch to

, select [SETUP] # [FORMAT CARD]

# [YES] from the menus, and then press

and hold down the Optical image

stabilizer/Delete button for approximately

3 seconds on the screen below. When the

SD card data deletion screen appears,

select [YES], and then follow the on-

screen instructions.

For the physical format, connect the unit to

the AC adaptor, set the mode switch to

, select [SETUP] # [FORMAT

MEDIA] # [SD CARD] from the menus,

and then press and hold down the Optical

image stabilizer/Delete button for

approximately 3 seconds on the screen

below. When the SD card data deletion

screen appears, select [YES], and then

follow the on-screen instructions.

≥ The customer is responsible for the

management of the data in the SD card.

About status indicator during

charging

About the SD card

HC-V100&V100MEB_VQT3Y11_mst.book 104 ページ２０１２年１月８日　日曜日　午後２時１８分

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 115 116

Comments to this Manuals

No comments