Panasonic WVCS650_SERIES Operations Instructions download pdf (Page 31)

- 28 -

Important Notices:

• The object of motion detection should meet the following conditions.

1) It should be larger than 1/48 of the size of the picture screen.

2) The contrast ratio (at max. detection level) between the object and the background picture on the

screen should be more than 5%.

3) The time it takes the object to move from one end of the screen to the other should be more than

0.1 seconds.

• Also under the following conditions, mask or adjust the detection level to prevent malfunction.

1) When leaves or curtains etc, are swayed by the wind.

2) When a noisy picture exists such as under low light condition.

3) When the object is subjected to illumination by lighting equipment that constantly turns on and

off.

• The alarm signal will take about 0.2 second to reach the alarm terminal of the VTR, after the camera

detects the object.

Because the alarm signal is multiplexed on the video signal it may be mistakenly interpreted by other

video equipment as a time code signal. Therefore, when this camera is not used in a Panasonic

Intelligent CCTV System, select OFF to prevent the above from occurring.

10.Auto Focus Setting (AF MODE)

1. Move the cursor to AF MODE, and move the joystick to the left or

right to set auto focus operation mode.

MANUAL: The AF mode is activated by pressing the AF button of

the controller.

AUTO: AF mode is activated automatically after a manual

panning, tilting or zooming operation.

Note: AUTO in AF MODE is disabled unless SENS UP is set to

OFF. If SENS UP is not OFF, AF MODE is set automatically to

MANUAL.

2. To set an area

Move the cursor to MANUAL or AUTO, and press the CAM (SET)

key. The AF AREA SET menu is shown. Move the cursor to

AREA, and move the joystick to the left or right to select LARGE,

MID or SMALL for the area.

3. To confirm operation

To check auto focus operation, move the cursor to AF CHECK,

and press the CAM (SET) key.

Notes:

• When the electronic sensitivity enhancement (SENS UP) is active,

this function is automatically set to MANUAL.

• The auto focus lens may not function properly in AUTO under the

following conditions.

1. Dirt or water on window glass.

The auto focus may focus on the dirt or water.

2. Low lighting/illumination or zone marker is blinking.

3. Bright objects or high intensity objects.

4. Single colour with unfigured object such as white wall or fine

felt.

5. No centre objects, sloping objects.

6. Far and near objects on the screen.

** SET UP **

CAMERA ID OFF

ALC/MANUAL ALC

SHUTTER OFF

AGC ON

SENS UP OFF

SYNC LL

WHITE BAL ATW

MOTION DET OFF

AF MODE MANUAL

RET SPECIAL

Camera setting menu

** AF AREA SET **

AREA SMALL

AF CHECK

→

PUSH SW

RET

** AF AREA SET **

AREA SMALL

AF CHECK

→

PUSH SW

RET

Area setting menu

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Comments to this Manuals

No comments

Panasonic WVCS650_SERIES Operations Instructions Page 31

Comments to this Manuals

Related products and manuals for Camera accessories Panasonic WVCS650_SERIES