Main/Sub selection on SW4 {No.6) in the Extension
mode.
The WJ-PC10 located in the control site should be
set to Main (OFF) position and the WJ-PC10 located
in the camera site should be set to the Sub (ON)
position as shown.
Sub
Main
■ Camera site
L
■ Control site ■
J
CN10/CN11 ; Selection of RS-232C cable
The Straight RS-232C Cable should be used with
WJ-PC10.
1. When WJ-PC10 is used as a DCE mode,
connect the cable on the board to the CN10
(STR).
2. When WJ-PC10 is used as a DTE mode,
connect the cable on the board to the CN11
(CROSS).
- 9 -
Comments to this Manuals