Panasonic PT-AE700U User Manual download pdf (Page 27)

Care and maintenance

ENGLISH-5352-ENGLISH

, Press and hold the ENTER

button for approximately 3

seconds.

The “LAMP RUNTIME” will

change to “TIME RESET

[POWER OFF]”.

B If the MENU button is pressed,

the lamp time resetting screen

will be cancelled.

- Turn off the power.

This will reset the cumulative

usage time for the lamp unit to

zero.

Refer to page 26 for details on

how to turn off the power.

' Install the lamp unit cover, and

then use a Phillips screwdriver

to securely tighten the lamp

unit cover fixing screws.

( Insert the power cord plug into

the wall outlet and then press

the MAIN POWER switch.

) Press the POWER button so

that a picture is projected onto

the screen.

* Press the MENU button to

display the “MAIN MENU”, and

then press the F or G button

to select “OPTION”.

+ Press the ENTER button to

display the “OPTION” menu,

and then press the F or G

button to select “LAMP

RUNTIME”.

KEYSTONE

PICTURE

POSITION

SHUTTER

LANGUAGE

OPTION

SELECT ENTER EXIT

OPTION

OSD ON

NR ON

CINEMA REALITY ON

BACK COLOR BLUE

WSS ON

FRONT/REAR FRONT

DESK/CEILING DESK

FAN CONTROL NORMAL

LAMP POWER HIGH

LAMP RUNTIME 2720H

SELECT ESC

OPTION

OSD ON

NR ON

CINEMA REALITY ON

BACK COLOR BLUE

WSS ON

FRONT/REAR FRONT

DESK/CEILING DESK

FAN CONTROL NORMAL

LAMP POWER HIGH

TIME RESET [POWER OFF]

SELECT ESC

NOTE:

B Be sure to install the lamp unit

and the lamp unit cover

securely. If they are not

securely installed, it may cause

the protection circuit to operate

so that the power cannot be

turned on.

Lamp unit replacement procedure

# Turn off the MAIN POWER

switch according to the

procedure given in “Turning off

the power” on page 26, and

then disconnect the power

cord plug from the wall outlet

and check that the area around

the lamp unit has cooled down.

$ Use a Phillips screwdriver to

turn the lamp unit cover fixing

screws at the bottom of the

projector, and then remove the

lamp unit cover.

% Use a Phillips screwdriver to

loosen the two lamp unit fixing

screws until the screws turn

freely. Then hold the handle of

the lamp unit and gently pull it

out from the projector.

& Insert the new lamp unit while

making sure that the direction

of insertion is correct, and then

use a Phillips screwdriver to

securely tighten the lamp unit

fixing screws.

When inserting the new lamp

unit, be sure to push it in at the

point A and B .

NOTE:

If the lamp usage time has passed 3 000 hours (when “LAMP POWER” has been

set to “HIGH” and when “DYNAMIC IRIS” has been set to “ON”), the projector will

switch to standby mode after approximately 30 minutes of operation. The steps

)

on the next page should thus be completed within 30 minutes.

Lamp unit cover

Lamp unit cover fixing screws

Lamp unit fixing screws

Handle

LAMP indicatorOn-screen display

Illuminates red during

image projection and

standby mode.

Displayed for 30

seconds. Pressing any

button will clear the

display.

More than 2 700 hours*

Remains displayed until

any button is pressed.

More than 3 000 hours*

These periods of time may become shorter according to the settings of the projector.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Panasonic PT-AE700U User Manual Page 27

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PT-AE700U