Panasonic CS-MKE12NB4U Operations Manual Page 17
- Page / 18
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
16
TROUBLESHOOTING
(BEFORE CALLING FOR SERVICE)
If your air conditioner does not work properly, first check the following
points before requesting service. If it still does not work properly,
contact your dealer or service center.
OPERATING RANGE
The air conditioner is operable within the temperature ranges as
listed below:
WIRED REMOTE CONTROLLER
A separately sold wired remote controller (CZ-RD515U)
used with this air conditioner is also available. If you wish
to use the wired remote control function, you will need to
purchase the optional wired remote controller.
Trouble Possible Cause Remedy
Air conditioner does
not run at all.
1. Power failure. 1. Restore power.
2. Leakage circuit
breaker tripped.
2. Contact service
center.
3. Line voltage is too
low.
3. Consult your
electrician or
dealer.
4. Batteries in remote
controller have run
down.
4. Replace batteries.
OPERATION lamp
blinks and air
conditioner does not
operate.
Trouble in system. Contact service
center.
Compressor runs but
soon stops.
Obstruction in front of
condenser coil.
(Outdoor Unit)
Remove obstruction.
Poor cooling (or
heating) performance.
1. Dirty or clogged air
filter.
1. Clean air filter to
improve airflow.
2. Heat source or
many people in
room.
2. Eliminate heat
source if possible.
3. Doors and/or
windows are open.
3. Shut them to keep
the heat (or cold)
out.
4. Obstacle near air
intake or air
discharge port.
4. Remove it to ensure
good airflow.
5. Thermostat is set
too high for cooling
(or too low for
heating).
5. Set the temperature
lower (or higher).
6. (Outdoor
temperature is too
low for heating.)
6. (Consult your
dealer or try to use
another heat
appliance.)
Clicking sound is
heard from the air
conditioner.
In heating or cooling
operation, any plastic
parts may expand or
shrink due to a
sudden temperature
change. In this event,
a clicking sound may
occur.
This is normal, and
the sound will soon
disappear.
OPERATION lamp
lights but outdoor unit
will not run.
The use of cellular
phones near the air
conditioner may cause
disturbance to its
normal operation.
1. Turn off the power
then restart the air
conditioner after a
while.
2. Consult your dealer.
TIMER lamp blinks
(3 sec. interval) and
air conditioner does
not operate.
FLOAT SWITCH is
actived.
Contact service
center.
Temperature Indoor air
temperature
Outdoor air
temperature
COOLING Max. 95 °F DB /
71 °F WB
115 °F DB
Min. 67 °F DB /
57 °F WB
14 °F DB
HEATING Max. 80 °F DB /
67 °F WB
75 °F DB /
65 °F WB
Min. – DB / – WB – DB / 0 °F WB
- CS-MKE9NB4U & CZ-18BT1U 1
- CS-MKE12NB4U & CZ-18BT1U 1
- Split System Air Conditioner 2
- Operating Instructions 2
- FEATURES 3
- CONTENTS 3
- PRODUCT INFORMATION 3
- SAFETY PRECAUTIONS 3
- INSTALLATION LOCATION 4
- ELECTRICAL REQUIREMENTS 4
- SAFETY INSTRUCTIONS 4
- NAMES OF PARTS 5
- UNIT DISPLAY AND OPERATION 5
- REMOTE CONTROLLER (DISPLAY) 6
- USING THE REMOTE CONTROLLER 9
- 1. Automatic Operation 10
- 2. Manual Operation 10
- 3. Adjusting the Fan Speed 11
- 4. Night Setback Mode 11
- 5. HIGH POWER Mode 11
- SPECIAL REMARKS 12
- SETTING THE TIMER 12
- 2. How to set the OFF time 13
- 3. How to set the ON time 13
- USING THE 1-HOUR OFF 14
- TIPS FOR ENERGY SAVING 14
- ADJUSTING THE AIRFLOW 14
- DIRECTION 14
- OPERATION WITHOUT THE 15
- REMOTE CONTROLLER 15
- CARE AND CLEANING 15
- TROUBLESHOOTING 17
- (BEFORE CALLING FOR SERVICE) 17
- OPERATING RANGE 17
- WIRED REMOTE CONTROLLER 17
- SPECIFICATIONS 18
Related products and manuals for Mobile air conditioners Panasonic CS-MKE12NB4U
(20 pages)
(21 pages)
(2 pages)StarTech.com HDMM8 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für HDMI-Kabel StarTech.com HDMM8.
Wir stellen 1 PDF-Handbücher StarTech.com HDMM8 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Datenblatt
Comments to this Manuals