Panasonic TH85PF12E Quick Start Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18
SLOT3
P
R
/C
R
/R P
B
/C
B
/B
Y/G
COMPONENT/RGB INLAN
AUDIO
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “Network Setup” setting and make sure to set the “Control I/F Select” to
“LAN”.
When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power “Off” with
remote control (stand-by state), regardless of the “Slot power” setting.
Example of Network Connection
Command Control
Hub or broadband router
LAN cable
(not supplied)
Notes:
Lay the LAN cable away from other connection cables (excluding the power cord).
Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
To connect a device using 100BASE-TX, use “category 5” LAN cable.
Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
For instructions on how to connect, consult your network administrator.
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 9)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Less
than
10 cm
Less
than
10 cm
Ferrite core
(supplied)
Ferrite core
(supplied)
Noise cut lter
(supplied)
Installing the Ferrite core
Pull back the tabs
(in two places)
Wind the cable twice
Open
Press the cable through
and close
Securing the LAN cable
Clamper
Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the
display unit.
When using a pedestal (TY-ST85P12) for the installation of the display, use a clamper supplied
with the display to secure the LAN cable. For use with another method of installation, refer to
the corresponding Installation Instructions.
COMPUTER
Display (main unit, rear)
Page view 17
1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments