Panasonic TH85PF12E Quick Start Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
SERIAL PC IN
AUDIO
SLOT1 SLOT3
P
R
/C
R
/R P
B
/C
B
/B
Y/G
COMPONENT/RGB IN LAN
SLOT2
AUDIO AUDIO
DVI-D IN
1
2
AUDIO OUT
R L
AUDIO OUT
R L
7
Connections
Stereophonic sound code
line-in
audio equipment
AUDIO OUT Terminals connection
AC cord connection (see page 11)
Pass the attached cable
xing band through the clip
as shown in the gure.
To secure cables connected to Terminals, wrap the cable xing band around them
then pass the pointed end through the locking block, as shown in the gure.
While ensuring there is suf cient slack in cables to minimize stress (especially
in the power cord), rmly bind all cables with the supplied xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
– AC cord xing
Note: Terminal board is installed in SLOT 2 and SLOT 3 at factory shipment.
– Cable xing band
Secure any excess cables with band as required.
Note:
Two xing bands are supplied with this unit. In case of securing cables at three positions, please purchase it separately.
Push
until
the hook
clicks.
2. Pull
off.
Close
Open
1
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
2
Fix the AC cord with the clamper.
Note:
Make sure that the AC cord is locked on both the left and right sides.
1. Keep the
knob
pressed.
Unplug the AC cord
Unplug the AC
cord pressing
the two knobs.
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet rst.
From SERIAL
Terminal on
Computer
(see page 9)
From input
on audio
ampli er
(see page 7)
From EXTERNAL
monitor terminal
on Computer
(see page 8)
DVI-D IN Terminals
(equivalent of DVI-D
Terminal Board
(TY-FB11DD))
(see page 10)
Optional
Terminal
Board Insert
Slot (covered)
COMPONENT/
RGB IN
Terminals
(see page 10)
LAN Terminal
(see page 18)
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments