Panasonic SCPMX7EG Operations Instructions download pdf (Page 11)

ENGLISH

VQT4X49

Reset the memory when the following situations occur:

• There is no response when buttons are pressed.

• You want to clear and reset the memory contents.

1 Disconnect the AC mains lead.

Wait 3 minutes before you continue with step 2.

2 While you press and hold [Í/I] on the main unit,

connect the AC mains lead again.

“- - - - - - - - - - - -” is shown.

3 Release [Í/I].

All the settings are set back to the factory preset.

It is necessary to set the memory items again.

When other Panasonic equipment responds to the

remote control of this system, change the remote control

code for this system.

To set the code to “Remote 2”

1 Press and hold [CD] on the main unit and [2] on

the remote control until “Remote 2” is shown.

2 Press and hold [OK] and [2] for a minimum of

4 seconds.

To set the code to “Remote 1”

1 Press and hold [CD] on the main unit and [1] on

the remote control until “Remote 1” is shown.

2 Press and hold [OK] and [1] for a minimum of

4 seconds.

Specifications

RMS output power stereo mode

Front Ch (both ch driven)

60 W per channel (3 ™), 1 kHz, 10% THD

Total RMS stereo mode power 120 W

Frequency modulation (FM)

Preset memory 30 stations

Frequency range

87.50 MHz to 108.00 MHz (50 kHz step)

Antenna terminals 75 ™ (unbalanced)

“iPod_Port” connection

DC OUT 5 V 2.1 A (max)

USB standard USB 2.0 full speed

Media file format support MP3 (*.mp3)

USB device file system FAT12, FAT16, FAT32

“iPod_Dock” connection

DC OUT 5 V 1.0 A (max)

Headphones jack Stereo, Ø 3.5 mm jack

AUX input (rear) Pin jack

Disc played (8 cm or 12 cm)

CD, CD-R/RW (CD-DA, MP3)

Pick up

Wavelength 790 nm (CD)

Laser power CLASS 1

NORSK

Bølgelengde 790 nm (CD)

Laserstyrke Ingen farlig stråling sendes ut

Audio output (Disc)

Number of channels 2 ch (FL, FR)

Speaker unit(s)

Woofer 14 cm cone type x 1

Tweeter 1.9 cm dome type x 1

Super tweeter 1.5 cm piezo type x 1

Impedance 3™

Dimensions (W x H x D) 161 mm x 238 mm x 262 mm

Mass 2.6 kg

Bluetooth

system specification V3.0

Wireless equipment classification Class 2

Supported profiles A2DP, AVRCP, GAVDP

Frequency band 2402 MHz to 2480 MHz

(Adaptive Frequency Hopping)

Driving distance 10 m Line of sight

Prospective communication distance

Measurement environment:

Temperature 25 oC / Height 1 m

Measure in “Mode 1”

Power supply AC 220 V to 240 V, 50 Hz

Power consumption 60 W

Dimensions (W x H x D) 210 mm x 120 mm x 266 mm

Mass Approx. 3 kg

Operating temperature range 0°C to +40°C

Operating humidity range

35% to 80% RH (no condensation)

Note:

• Specifications are subject to change without notice. Mass

and dimensions are approximate.

• Total harmonic distortion is measured by the digital

spectrum analyzer.

Memory reset (initialisation)

Remote control code

Amplifier section

Tuner section

Terminals section

Disc section

Speaker section

Bluetooth

section

General

Power consumption in standby mode

(

When the iPod/iPhone/iPad is not charging)

0.4 W (approximate)

Declaration of Conformity (DoC)

Hereby, “Panasonic Corporation” declares that this product

is in compliance with the essential requirements and other

relevant provisions of Directive 1999/5/EC.

Customers can download a copy of the original DoC to our

R&TTE products from our DoC server:

http://www.doc.panasonic.de

Contact to Authorised Representative: Panasonic Marketing

Europe GmbH,

Panasonic Testing Centre, Winsbergring 15, 22525

Hamburg, Germany

This product is intended for general consumer. (Category 3)

1731

SC-PMX7EG-VQT4X49.book 11 ページ２０１３年１月２５日　金曜日　午前１０時３１分

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comments to this Manuals

No comments

Panasonic SCPMX7EG Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Smartwatches Panasonic SCPMX7EG