Panasonic CS-MKE12NKU Operations Manual download pdf (Page 11)

REMOTE CONTROLLER (CONTINUED)

USING THE REMOTE CONTROLLER

Temperature Display Selector

button

This switches the temperature display between °C and °F.

Time Display Selector button This switches the time display between 24-hour time and 12-hour time.

ACL button (ALL CLEAR) Puts the remote controller into pre-operation status. Always press this button

after replacing the batteries.

ADDRESS switch • The address switch changes to prevent mixing of signals from remote

controller’s when two air conditioners are installed next to each other.

Normally, the address switch is set to A. For more information, please contact

the dealer where you made the purchase.

• Normally, the tabs on the remote controller should not be bent.

The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals.

If the signal from the remote controller stops for more than 15 minutes due to the loss of the remote

controller or other trouble, the air conditioner will switch to the temperature sensor which is built into the

indoor unit and control the room temperature. In these cases, the temperature around the remote

controller may differ from the temperature detected at the air conditioner’s position.

How to Install Batteries

• The batteries last about six months, depending on how much you use

the remote controller. Replace the batteries when the remote controller’s

display fails to light, or when the remote controller cannot be used to

change the air conditioner’s settings.

• Use two fresh leak-proof type-AAA alkaline batteries.

• In replacing batteries, follow the instructions as mentioned in the

subsection “How to Install Batteries”.

• If you do not use the remote controller more than 1 month, take out the

batteries.

• Dispose of the used batteries at the designated location in compliance

with the applicable local ordinances.

Information for Users on Collection and Disposal of Old Equipment and used Batteries

[Information on Disposal in other

Countries outside the European Union]

These symbols are only valid in the

European Union. If you wish to discard these

items, please contact your local authorities

or dealer and ask for the correct method of

disposal.

Note for the battery symbol (bottom two

symbol examples):

This symbol might be used in combination

with a chemical symbol. In this case it

complies with the requirement set by the

Directive for the chemical involved.

NOTE

1. Slide the cover in the direction indicated by the arrow

and remove it.

2. Install two AAA alkaline batteries. Make sure the

batteries point in the direction marked in the battery

compartment.

3. Use a thin object such as the tip of a pen to press the

ACL button.

ACL button

CAUTION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Comments to this Manuals

No comments

Panasonic CS-MKE12NKU Operations Manual Page 11

Comments to this Manuals

Related products and manuals for Split-system air conditioners Panasonic CS-MKE12NKU