Panasonic CS-S9NKUA Service Manual download pdf (Page 26)

9. Secure the wire onto the control board with the holder

(clamper).

10. After completing wiring connections, reattach the control

board cover (Metal and Resin) and the top panel to the

original position with the screws.

11. For wire stripping and connection requirement, refer to

instruction g of indoor unit.

o Earth lead wire shall be Yellow/Green (Y/G) in colour

and shall be longer than other lead wires as shown in

the figure for electrical safety in case of the slipping.

10.1.4.5 Piping Insulation

1. Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation

Diagram. Please wrap the insulated piping end to prevent water from going inside the piping.

2. If drain hose or connecting piping is in the room (where dew may form), please increase the insulation by

using POLY-E FOAM with thickness ¼” or above.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 73 74

No comments

Panasonic CS-S9NKUA Service Manual Page 26