Panasonic EY6535 User Manual download pdf (Page 9)

—

9

—

Using Quick change chuck

(EY9HX110)

This Quick change chuck is

designed to be used with Pana-

sonic EY6535.

Top collar : To insert or to

remove bit.

Bottom collar: To attach or to

detach Quick

change chuck.

Use 6.35mm (1/4") hexagonal bits.

To ensure proper securement of the bit, use only

hexagonal bits with 9.25mm (3/8") detent.

CAUTION: Make sure the work environment is

safe. When retracting bit from work

material, Quick change chuck may

detach if subjected to 50kg or more

of pull force. Detachment will be sud-

den. Use care and avoid excessive

force when retracting bit from work

material.

1. Attaching Quick change chuck

Attach the Quick change chuck by pulling the

bottom collar forward and sliding the female

detent on the bottom of the chuck to the

square drive on the body.

Release the bottom collar to make sure the

Quick change chuck is firmly connected to the

body.

2. Inserting the bit

Pull the top collar of the Quick change chuck

forward, then insert the bit.

Release the bottom collar to make sure the bit

is firmly connected to the chuck.

3. Removing the bit

Pull the top collar of the Quick change chuck

forward, then pull the bit.

CAUTION: lmpact mechanism creates heat.

Square drive and accessory may

become very hot and may cause skin

burns. To prevent skin burns, use

work gloves and/or allow heated

parts to cool down before handling.

4. Detaching Quick change chuck

Pull the bottom collar of the Quick change

chuck forward to detach it.

Attaching or removing battery

pack

1. To connect the battery pack:

Insert the battery pack. It snaps into place to

indicate proper connection.

2. To remove the battery pack:

Press the two buttons on the sides of the bat-

tery pack. Slide the battery pack out of the tool

body.

OPERATION

Switch Operation

1. The speed increases with the amount of

depression of the trigger. When beginning

work, depress the trigger slightly to start the

rotation slowly.

2. A feedback electronic controller is used to

give a strong torque even in low speed.

3. The brake operates when the trigger is

released and the motor stops immediately.

Reversing Lever Operation

(Forward ( ), Switch lock, Reverse ( ))

CAUTION: Do not operate reversing lever until

rotation of the spindle comes to a

complete stop. Shifting during rota-

tion of the chuck may damage the

tool.

1. For reverse rotation, set the lever to reverse.

Check the direction of rotation before use.

Top collar

Bottom collar

6.35mm (1/4")

9.25mm (3/8")

1

2

Top Collar

1

2

EY6535.book 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments