4
English
Antenna Connection
VHF Antenna UHF Antenna
75 Ω
Coaxial
Cable
Ferrite core
(included)
Ferrite core
(included)
F-type antenna
adapter (included)
Note
•
To obtain optimum quality picture and sound,
an Antenna, the correct cable (75 Ω coaxial)
and the correct terminating plug are required.
• If a communal Antenna system is used, you
may require the correct connection cable
and plug between the wall Antenna socket
and your television receiver.
• Your local television service center or dealer
may be able to assist you in obtaining the
correct Antenna system for your particular
area and the accessories required.
• Any matters regarding Antenna installation,
upgrading of existing systems or
accessories required, and the costs
incurred, are your responsibility.
For proper reception of VHF/UHF channels, an external antenna is required. For best reception, an outdoor antenna is
recommended. The antenna mode must be set to “TV” (see page 11, SET UP menu
-
MODE).
Connection
1.Remove the
slot cover.
2.Insert the terminal board
until it is firmly plugged
into the connector.
Tighten screws in the
order 1
-
4 .
3.Affix the terminal
function label
(included).
To install
75 Ω VHF/UHF
Remove the slot cover. Grip the
handle of the terminal board, and
slowly pull out in the direction of
the arrow.
To remove
• Make sure that the Board does not ride on the two lower claws.
• Be sure to fasten all screws tightly.
•
Have the customer keep the removed Terminal Board for future servicing needs.
Mixer
Securing screw
Compatible slot Nos. are SLOT1 and SLOT2.
SLOT3 is not
compatible.
Precautions
• Before installation
T
urn the power switch off and disconnect the plug of the display. Disconnect all the plugs connected to the display.
• Before removing, turn the power off with the tuner board’s remote control and then turn the main power off.
• When installing or removing the terminal board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the board that could cause unexpected injury.
• When installing the board, fully insert the Board into the slot horizontally until it is firmly plugged into the
connector.
N
ote that incomplete insertion may damage the internal components.
Foam mat or thick soft cloth
SERIALPC IN
AUDIO
SERIALPC IN
AUDIO
2 slots model
3 slots model
• Terminal function label
SLOT1
SLOT2
SLOT3SLOT2
SLOT1
Installation
Comments to this Manuals