Panasonic CS-KS18NKU Service Manual download pdf (Page 109)

3-9. Mounting

(1) To install the indoor unit, mount the indoor unit onto

the 2 tabs on the upper part of the rear plate.

(2) Hold down the air discharge outlet and press the

lower part of the indoor unit until it clicks to securely

fasten to the 2 tabs on the lower part of the rear

plate. (Fig. 33)

For tubing, choose either the right or left tubing direction

and follow the steps below. This work can be made easi-

er by placing padding material (such as styrofoam) at the

rear right side of the indoor unit. (Fig. 34)

 Right-side tubing

(1) Shape the refrigerant tubing so that it can easily go

into the wall hole. (Fig. 35)

(2) Push the wiring, refrigerant tubing, and drain hose

through the hole in the wall. Adjust the indoor unit so

it is securely seated on the rear panel. (Fig. 36)

(3) Carefully bend the tubing (if necessary) to run along

the wall in the direction of the outdoor unit and then

tape as far as the fittings. (See Caution on page

21.) The drain hose should come straight down the

wall to a point where water runoff won’t stain the

wall.

(4) Connect the refrigerant tubing to the outdoor unit.

(After performing a leak test on the connecting part,

insulate it with the tubing insulation. (Fig. 37a)) Also,

refer to Section 5-4. Connecting Tubing between

Indoor and Outdoor Units.

(5) Assemble the refrigerant tubing, drain hose, and

conduit (including inter-unit wiring) as shown in

Fig. 37b.

NOTE

Cover

Refrigerant

tubing

Rear panel

Drain hose

Inter-unit

wiring

Fig. 35

Fig. 36

Fig. 33

Push

Fig. 34

Insulation

Refrigerant tubing

Drain hose

Conduit

Inter-unit wiring

Padding material

Fig. 37a

Fig. 37b

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 121 122

Comments to this Manuals

No comments

Panasonic CS-KS18NKU Service Manual Page 109

Comments to this Manuals

Related products and manuals for Unknown Panasonic CS-KS18NKU