Panasonic WV-CF324 User Manual download pdf (Page 11)

● Direct mounting

If the camera is directly mounted on a

wall/ceiling, align the camera mounting posi-

tion with the position of the hole through

which the cables run and make the hole.

If no hole is made through a wall/ceiling and

open wiring along a wall/ceiling is used,

process the cover so that the cables can be

run through the side of the cover.

Installations and Connections

The following installation should be made by qualified service personnel or system installers.

■ Preparations

Important:

• Procure 4 mounting screws according to the material of the installation area. In this case,

wood screws and nails should not be used.

Recommended tightening torque is as follows.

M4: 1.6 N·m {1.18 lbf·ft}

• Required pull-out capacity of

a single screw/bolt is 196 N

{44.1 lbf} or more.

• If a ceiling board such as

plaster board is too weak to

support the total weight, the

area shall be sufficiently rein-

forced.

• The protection sheet attached

to the dome cover shall be

peeled off after installation.

Camera fixing hole

ø4 - 4.5 mm {0.16" - 0.18"}

4.5 mm

{0.18"}

83.5mm {3.29"}

ø146mm {5.75"}

46 mm {1.81"}

Side cable access hole

Cable access hole

for wall/ceiling

ø30 - 50 mm {1.18" - 1.97"}

● Using a two-gang junction box

When using a two-gang junction box (4" x

4"), procure one locally that meets the

dimensions in the figure.

And then, locally procure four camera-

mounting screws suitable for the installation

surface and structure of the wall/ceiling or

two-gang junction box.

Processed section of the side

surface of the cover

Caution:

ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Panasonic WV-CF324 User Manual Page 11

Comments to this Manuals

Related products and manuals for Video surveillance systems Panasonic WV-CF324