Panasonic NVGS500 Operations Instructions download pdf (Page 73)

Before using

73

VQT0T42

Quick Start

When quick start is ON the battery power is still

being consumed, even when the LCD monitor

and the viewfinder are closed.

The movie camera will resume recording/pause

mode about 1.7 seconds after the LCD monitor or

the viewfinder is reopended.

≥Please note in quick start mode approximately

half the pause recording power is being

consumed. Using quick start mode will reduce

the battery recording/playback time.

≥This is only activated in the following cases.

≥A tape or a card is inserted, while the Tape

Recording Mode is set.

≥A card is inserted, while the Card Recording

Mode is set.

≥Set to Tape/Card Recording Mode.

1 Set [SETUP] >> [QUICK START] >> [ON].

(

-78-)

2 While the [OFF/ON] switch is still set to

[ON], close the LCD monitor and retract the

viewfinder.

≥The Status indicator lights green and the unit

goes into quick start standby mode.

≥The movie camera will not go into quick start

standby mode unless the LCD monitor is

closed and the viewfinder is retracted.

3 Open the LCD monitor or extend the

Viewfinder.

≥The Status indicator lights red and the

camera is put into recording pause approx.

1.7 seconds after it is turned on.

ª

To cancel Quick Start

1 Set [SETUP] >> [QUICK START] >> [OFF].

(

-78-)

≥If the [OFF/ON] switch is set to [OFF] while the

unit is in quick start standby mode, the power

turns off.

≥If the standby continues for approx. 30 minutes,

then the Status indicator will go off and the

camera will be completely turned off.

≥If the Mode dial is moved or the battery is

removed in quick start standby mode, quick

start is cancelled and the power turns off.

≥When the movie camera is quick-started with

the white balance on automatic, it may take

some time until the white balance is adjusted if

the scene being recorded has a light source

different from the scene last recorded. (When

the colour night view function is used, however,

the white balance of the scene last recorded is

retained.)

≥If the power is turned on in quick start standby

mode, the zoom magnification becomes 1k and

the picture size may differ from what it was

before quick start standby mode.

≥If [POWER SAVE] (

-114-) is set to [5 MINUTES]

and the unit automatically goes into quick start

standby mode, set the [OFF/ON] switch to

[OFF], then to [ON] again. Also, close the LCD

monitor and retract the viewfinder and then

open the LCD monitor or extend the viewfinder

again.

≥When using the AC adaptor, Quick Start can be

used even if a tape/card is not inserted.

OFF

ON

OFF

ON

VQT0T42_GC_Eng.book 73 ページ２００６年１月５日　木曜日　午後４時３１分

1 ... 72 73 74 ... 132

Comments to this Manuals

No comments