Panasonic SDRS100 Operations Instructions download pdf (Page 19)

VQT0T50

To cancel quick start

Press the menu button, use the cursor button to select [ SETUP]#

[ QUICK START]#[OFF]. (P26)

≥ To cancel quick start standby, turn off the

power.

≥ Quick start standby is canceled after

5 minutes have elapsed.

In this case, the unit cannot be

quick-started and it takes longer for it to

start operating.

≥ Quick start standby is canceled if the

mode dial is switched to a mode other

than motion picture recording mode or

still picture recording mode.

≥ Since about half the power of normal

recording is used in quick start standby,

using quick start reduces the recordable

time.

≥ If quick start is not set, it takes longer for

this unit to start operating, but the

amount of power consumed when the

LCD monitor is closed is reduced.

≥ When the LCD monitor is opened in

quick start standby status, the zoom

magnification is set to the 1k

(approximately). This may cause the size

of the image to be different from the size

before standby status was established.

≥ When this unit is quick-started with the

white balance on automatic, it may take

some time until the white balance is

adjusted if the scene being recorded has

a light source different from the scene

last recorded. (When the MagicPix

function is used, however, the white

balance of the scene last recorded is

retained.)

VQT0T50_PP_ENG.book 19 ページ２００５年８月３１日　水曜日　午後２時２５分

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 119 120

No comments

Panasonic SDRS100 Operations Instructions Page 19