Panasonic WV-CP300 Installation Guide download pdf (Page 14)

3 Installation of safety wire

The following example shows the installation of safety wire:

Important:

• Be sure to install safety wire between the camera and the installation position to prevent unex-

pected injury caused by fallen camera.

• Ensure that the safety wire is installed. Consult the dealer about installation.

Attach the safety wire lug (accessory) to the screw hole of the mount

base with screw (accessory).

1 Loosen one screw in the front portion of the

camera upper case. (Either left or right)

2 Be sure to attach the safety wire lug (accessory)

with the wire lug fixing screw (M2.5 × 8 mm

{5/16 inches}) provided in the accessories.

Important:

• Be sure to attach the safety wire lug (accessory)

with the screw provided in the accessories. Using

screw of different length may cause camera drop

or damage.

•

Do not install the safety wire lug at places other than

the two screw holes of the upper case.

• Do not install the safety wire lug on the projec-

tions of the upper case. (Install the safety wire lug

between the two projections)

• Recommended tightening torque: 0.39 N·m

{0.29 lbf·ft}.

Screws of

upper case

Wire engaging hole

Wire lug ﬁxing

screw (accessory)

Safety wire lug

(accessory)

Engage the safety wire with the wire engaging hole.

1 Pass one end of the safety wire eyelet through the wire engaging hole.

2 Pass the other end of the safety wire through the eyelet.

Safety wire

Wire engaging

hole

PGQX1142YA_WV-CP300_G.indd 14 2012/3/30 16:53:36

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Panasonic WV-CP300 Installation Guide Page 14