Panasonic WV-CW504 Installation Guide download pdf (Page 14)

Preparations

When installing the camera on a wall or a ceiling, there are two methods as specified below.

(+ Next page)

 • Usingatwo-gangjunctionbox

 • Usingthecameramountbracket(accessory)

Refer to all work related to the installation of this product to qualified service personnel or system

installer.

Important:

 • Preparethemounting screwaccordingto thematerial of theareawherethe camera attach-

ment (accessory) is to be installed. In this case, wood screws and nails should not be used.

For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4)

for securing.

(Recommended tightening torque M4: 1.6 N·m)

 • Whenusingtheprovidedcameraattachment,makesurethateitherofthearrowmarksfaces

upward.

 • Requiredpull-outcapacityofasinglescrew/boltis196Normore.

 • Ifaceilingboardsuchasplasterboardistooweaktosupportthetotalweight,theareashall

be sufficiently reinforced.

 • Whenusinganoptionalmountingbracket,refertotheoperatinginstructionsofthebracketin

use.

The mounting conditions of the camera mount bracket are described as follows:

Installation

place

Applicable mount

bracket

Recommended

screw

Number

of screw

Minimum pull-out

strength

(per 1 pc.)

Ceiling/wall (Two-gang junction box) M4 or equivalent 4 pcs. 196 N

Ceiling/wall Camera mount bracket

(approx. 350 g)

M4 or equivalent 4 pcs. 196 N

Ceiling WV-Q169

(approx. 700 g)

– – *

* Make sure that the installed mount bracket can support more than 5 times of the weight of the

camera.

1 ... 13 14 15 ... 44

No comments

Panasonic WV-CW504 Installation Guide Page 14