Panasonic HDCSD5 Operations Instructions Page 117
- Page / 136
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Others
117
VQT1H64
Troubleshooting
ª Unit operations
Problem Check points
This unit cannot be
turned on.
≥ Is the battery fully charged?
# Charge it with the AC adaptor. (l 23)
≥ The battery protection circuit may have operated. Attach the battery
to the AC adaptor for 5 to 10 seconds. If the unit still cannot be
used, the battery is faulty.
≥ Is the LCD monitor open?
This unit is turned off
automatically.
≥ If you do not use the unit for approximately 5 minutes, the power is
automatically turned off to conserve the battery charge. To resume
recording, turn the power back on.
The power will not turn off automatically when the power save
function (l 111) is set to [OFF].
≥ Are you connecting to a TV compatible with VIERA Link with a
HDMI cable?
# If you connect to a TV compatible with VIERA Link with a HDMI
cable and turn off the power on the TV with the remote control for
the TV, the power on this unit also turns off. If you are not using
VIERA Link, set [VIERA Link] to [OFF]. (l 84)
This unit does not stay
on long enough.
≥ Is the battery low?
# If the remaining battery power indication is flashing or the
message “CHANGE THE BATTERY.” is displayed, the battery
has run down. Charge the battery. (l 23)
Battery runs down
quickly.
≥ Is the battery fully charged?
# Charge it with the AC adaptor. (l 23)
≥ Are you using the battery in an extremely cold place?
# The battery is affected by ambient temperature. In cold places,
the operating time of the battery becomes shorter.
≥ Has the battery worn out?
# The battery has a limited life. If the operating time is still too short
even after the battery is fully charged, the battery has worn out
and can no longer be used.
The minute display of the
remaining battery power
indication is not
displayed correctly.
≥ The remaining battery capacity indication is an approximation.
If you think the remaining battery capacity indication is not
displayed correctly, fully charge the battery, discharge it and then
charge it again. (Even if this operation is performed, it may not be
possible to display the remaining battery capacity correctly if the
battery was used for a long period of time where the temperature
was low or high or if the battery was repeatedly charged.)
HDCSD5-VQT1H64_eng.book 117 ページ ２００７年８月１日 水曜日 午後７時１６分
- Operating Instructions 1
- Information for your safety 2
- Caution for AC mains lead 3
- Contents 6
- Before using 8
- ª What is the VIERA Link? 10
- ª Other linked operations 10
- Saving data to a disc 11
- Important Notice 11
- ª The SD Media Storage 12
- Saving data to a computer 12
- (For United Kingdom) 13
- Accessories 14
- Parts identification and 15
- 1 Flip the belt 16
- 3 Replace the belt 16
- Using the LCD monitor 18
- Using the remote control 19
- ª Handling precautions 21
- Charging the battery 23
- ª Charging time 25
- ª Recordable time 25
- Selecting a mode 28
- (Turning the unit on/off) 28
- Quick start 29
- 3 Open the LCD monitor 29
- How to use the cursor button 31
- 1 Move the cursor button up 31
- 2 Move the cursor button up 31
- Recording mode 32
- To exit the help mode 34
- To exit the menu screen 35
- Adjusting LCD monitor 37
- POWER LCD 38
- Recording 39
- ª About auto mode 40
- Anti-Ground-Shooting (AGS) 40
- Recording motion pictures 41
- 2 Open the LCD monitor 41
- 1 Open the LCD monitor 42
- 2 Press the PRE-REC button 42
- To end PRE-REC 43
- ABCD E FG H 46
- Number of pixels and picture 47
- Various recording functions 48
- Recording yourself 49
- Intelligent contrast control 50
- Fade in/fade out function 50
- Colour night view function 51
- Soft skin mode 52
- Backlight compensation 52
- Self-timer recording 53
- Built-in flash 53
- When the flash is not used 54
- Tele macro function 55
- Image stabilizer function 55
- Guide line function 56
- Wind noise reduction function 56
- Microphone level 57
- Zebra display 58
- Colour bar 58
- Manual recording functions 59
- 1 Set the AUTO/MANUAL/FOCUS 59
- 2 Set the AUTO/MANUAL/FOCUS 60
- Playback 64
- or 5 button during playback 65
- Repeat playback 67
- Playing back motion pictures 67
- Still picture (JPEG) playback 68
- 4 Press the cursor button 69
- 5 Move the cursor button to 69
- Deleting scenes 70
- Dividing a scene to delete 71
- Protecting scenes 72
- Deleting still pictures 73
- Protecting still pictures 74
- DPOF setting 75
- Card management 76
- With other products 77
- HDMI output resolution 79
- COMPONENT 80
- VIDEO IN 81
- AUDIO IN 81
- DISPLAY ON/OFF 84
- With a DVD burner 85
- 1 Press the DISC COPY button 87
- 2 Copy to the disc. (l 85) 90
- With a DVD recorder or video 91
- With a printer (PictBridge) 92
- With a computer 94
- Contents on provided CD-ROM 95
- End User License Agreement 96
- Operating environment 97
- 6 Click [Finish] 100
- Connection and recognition 101
- 3 Connect this unit and a 101
- About the computer display 102
- 2 Select [USB Mass Storage 103
- 3 Click , select the save 106
- 4 Click and then select 107
- If using Macintosh 108
- Menus and Indications 109
- [] motion picture playback) 110
- [] still picture playback) 110
- [] disc playback) 110
- 0h00m00s 111
- Indications 112
- Messages 114
- About recovery 115
- Troubleshooting 117
- ª With a computer 121
- 122
- ª When deleting scenes 123
- 25.5.2007 125
- Cautions for use 126
- About the battery 127
- About the AC adaptor 127
- About the SD card 128
- About the miniSD Card 128
- LCD monitor 128
- Explanation of terms 129
- White balance 130
- Auto focus 130
- Specifications 131
- F0807MA0 ( 8000 A ) 136
- Panasonic Testing Centre 136
Related products and manuals for Camcorders Panasonic HDCSD5
(29 pages)
(128 pages)
(128 pages)
(220 pages)
(36 pages)
(100 pages)
(136 pages)© 2020, manymanuals.com. All rights reserved. | 0.391 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals