Panasonic HDCZ10000E User Manual download pdf (Page 32)

- 32 -

Convergence point adjustment

∫ About the convergence point

Convergence point is a position that becomes the reference plane of the 3D image.

When viewing the 3D image, a subject located closer than the convergence point is

displayed in front of the screen, and a subject located farther than the convergence point is

displayed behind the screen.

∫ Adjusting the convergence point

It is recommended to prepare for recording, such as adjust the convergence point in

accordance with the position of the subject in advance, determine the construction of the

image to record, etc., to record an image that is effective as 3D video. It is also

recommended to adjust the convergence point again when the distance between this unit

and the subject is changed significantly.

1 Display the convergence.

To ensure that the 3D image can be safely viewed, pay attention to the following

points when adjusting the convergence point.

≥ The image may cause tiredness or discomfort when adjustment of the convergence point

is frequently performed, or the position of the subject is further away in front or rear of the

convergence point or at the edge of the image.

≥ Stop the operation when you feel fatigue, discomfort, or otherwise strange while

adjusting.

: [SW & DISP SETUP] # [CONVERGENCE] # [ON]







A Convergence point

B Display in front of the screen

C Display behind the screen

* The image is an illustration.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 143 144

No comments

Panasonic HDCZ10000E User Manual Page 32