Panasonic CQ VAD9300U User Manual download pdf (Page 75)

□ Installation Hardware (For Wiring)

No.

Item

Diagram

Qty

Power Connector

(for display unit)

Reverse Extension Cord

(for rear view camera)

Clip Connector

Display Unit/Hide-away Unit

Connecting Cord

Optical Fiber Cable

•o

Power Connector

(for hide-away unit)

Ground Lead

Radio Antenna Extension

Cord

■r"

Center Speaker Lead

Center Speaker Extension

Lead

Before you begin installation, iook for the following items

which are packed with your unit.

• Warranty Card

.......

Fill this out promptly.

• Panasonic Servicenter for Service Directory

...............

Keep for future reference in case the product needs

servicing.

• Installation Hardware

........

Needed for Installation.

□ Before Installation

Warning

• Do not install the monitor in a location which

obstructs driving, visibility or which is prohibited by

applicable laws and regulations. If the monitor is

installed in a location which obstructs forward visibility

or operation of the air bag or other safety equipment or

which interferes with operation of the car, it may cause

an accident.

• Never use bolts or nuts from the car's safety devices for

installation. If bolts or nuts from the steering wheel,

brakes or other safety devices are used for installation

of the monitor, it may cause an accident.

•

• Attach the wires correctly. If the wiring is not correctly

performed, it may cause a fire or an accident. In particu

lar, be sure to run and secure the lead wire so that it

does not get tangled with a screw or the moving portion

of a seat rail.

• Use with 12 volt DC negative ground car. This unit is

only for use with a 12 volt DC negative ground car. It

cannot be used in large trucks or diesel cars which are

24 volt DC cars. If it is used in the wrong type of car, it

may cause a fire or an accident.

Cautions:

• Use the specified fuse. Be sure to always use the

specified fuse. If a fuse other than the specified fuse

is used, it may cause a fire or an accident.

• Do not damage the cord by pinching or pulling it. Do

not pull or damage the cord. If the cord is not treated

properly, it will short out or be severed and may

cause a fire or an accident.

□ Required Tools

You’ll need a screwdriver and the following;

12 V DC

Test Bulb

Electrical

Tape

Side-Cut

Pliers

□ Dashboard Specifications

THICKNESS

MIN. 3/16” (4.75 mm)

II-— MAX. 7/32” (5.56 mm)

2-3/32” (53 mm)

7-5/32” (182 mm)

□ Identify All Leads

The first step in instailation is to identify all the car wires

you’ll use when hooking up your LCD monitor.

As you identify each wire, we suggest that you label it

using masking tape and a permanent marker. This will

help avoid confusion when making connections later.

Note: Do not connect the power connector to the display

unit until you have made all connections. If there are no

plastic caps on the hooking wires, insulate all exposed

leads with electrical tape until you are ready to use them.

Identify the leads in the following order.

CQ-VAD9300U

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 303 304

Comments to this Manuals

No comments

Panasonic CQ VAD9300U User Manual Page 75

Comments to this Manuals

Related products and manuals for Car speakers Panasonic CQ VAD9300U