Panasonic TH-65PF10RK User Manual download pdf (Page 22)

Adjusting Pos. /Size

While the Pos. /Size display is active, if either the N button on the remote control is pressed at any time or the ACTION

( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.

Helpful Hint ( /

Normalise

Normalisation)

Auto Setup

Automatically adjust H-Pos / V-Pos / Clock Phase / Dot Clock and set H-Size / V-Size the

standard value when RGB signal is input.

Notes:

• If the dot clock frequency is 162 MHz or higher, Dot Clock cannot be made.

• If the image is that the edge is hardly ﬁ gured out or shadowy, that cannot be adjusted

automatically.

In such case, press Auto Setup again after changing the image to the clearer one.

• When DVI-D is input, Clock Phase cannot be adjusted automatically.

• Select Normalise in Pos. /Size and press the ACTION ( ) button when appropriate

adjustment cannot be made.

H-Pos Adjust the horizontal position.

H-Size Adjust the horizontal size.

V-Pos Adjust the vertical position.

V-Size Adjust the vertical size.

Dot Clock (During “Component”, “RGB” and “PC” input signal)

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this

happens, adjust so that any such noise is minimized.

Clock Phase (During “Component”, “RGB” and “PC” input signal)

Eliminate the ﬂ ickering and distortion.

1:1 Pixel Mode Adjusts the display size when 1125i, 1125p or 1250i signal is input.

Notes:

• Select On when you would like to replay 1920 × 1080 input signal.

• Applicable input signal;

1125 / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 / 50i

• Select Off when ﬂ ickering is shown around the image.

• H-Size, V-Size and Dot Clock cannot be adjusted when On is selected.

Off On

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

No comments

Panasonic TH-65PF10RK User Manual Page 22