Panasonic AW-RP555 User Manual download pdf (Page 24)

23 (E)

Operation

Turning on the power

1. Set all the power switches of the connected components and the power switch of the

AC adapter to ON.

2. Set this unit’s OPERATE switch to ON.

Power will be supplied to the pan/tilt head system connected to this unit, and the

camera’s initial settings will be performed in sequence.

 It takes about 5 seconds to perform the camera’s initial settings for each camera.

The pan/tilt head system cannot be controlled until these settings are completed.

 Be sure to set power switches on all connected equipment and AC adapters to

ON before setting the control panel’s OPERATE switch to ON.

When the pan/tilt head system is connected (or changed) and its power is turned on for the

first time, the connected cameras will be initialized. Upon completion of the initialization,

adjust or set the following items. After the items are adjusted or set, proceed to the section

entitled “Setting the travel range (limiters) of the pan/tilt head”.

Once the adjustments are made, there is no need for any re-adjustments unless changes

are made to the pan/tilt head, camera or lens. (The items to the re-set or re-adjusted differ

depending on the unit which is changed.)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 295 296

No comments

Panasonic AW-RP555 User Manual Page 24